Download KitchenAid KFRU488TSS User's Manual

INSTALLATION REQUIREMENTS
■
Rotisserie motor mounting bracket
■
1 single-prong plug/500 mAmp transformer assembly for the
rotisserie
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
■
Rotisserie motor
■
Rotisserie forks
Tools Needed
■
Rotisserie spit
■
Smoker box
Tools and Parts
Style 1 - Freestanding Outdoor Grills
■
Tape measure
■
Wrench or pliers
■
Small, flat-blade screwdriver
■
Pipe wrench
■
Flat-blade screwdriver
■
■
#2 and #3 Phillips screwdriver
Scissors or cutting pliers
(to remove tiedowns)
■
Level
■
Noncorrosive leakdetection solution
Location Requirements
WARNING
Parts Supplied
■
Gas pressure regulator/hose assembly set for 11" WCP LP
gas (attached to manifold).
■
Rotisserie motor mounting bracket
■
Rotisserie motor
■
Rotisserie forks
Do not store fuel tank in a garage or indoors.
■
Rotisserie spit
Do not store grill with fuel tank in a garage or indoors.
■
Smoker box
■
2 warming drawer pans
Failure to follow these instructions can result in death,
explosion, or fire.
■
1 single-prong plug/500 mAmp transformer assembly
Explosion Hazard
Parts Needed
■
WARNING
20 lb LP gas fuel tank
Tools and Parts
Style 2 - Built-In Outdoor Grills
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Fire Hazard
Tools Needed
Do not use grill near combustible materials.
■
Tape measure
■
Wrench or pliers
■
Small, flat-blade screwdriver
■
Pipe wrench
■
Flat-blade screwdriver
■
■
#2 and #3 Phillips screwdriver
Scissors or cutting pliers
(to remove tiedowns)
■
Level
■
Noncorrosive leakdetection solution
Parts Needed
■
Gas line shutoff valve
■
½" male pipe thread nipple for connection to pressure
regulator
■
LP gas-resistant pipe-joint compound
■
CSA design-certified outdoor flexible stainless steel
appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas supply
line as needed.
Parts Supplied
■
Convertible regulator set for 4" WCP Natural gas.
■
1 single-prong plug/5,000 mAmp transformer assembly for
the grill
Do not store combustible materials near grill.
Doing so can result in death or fire.
Select a location that provides minimum exposure to wind and
traffic paths. The location should be away from strong draft
areas.
Do not obstruct flow of combustion and ventilation air.
Clearance to combustible construction for built-in and
freestanding outdoor grills:
■ A minimum of 24" (58 cm) must be maintained between the
front of the grill hood, sides and back of the grill and any
combustible construction.
■
A 24" (58 cm) minimum clearance must also be maintained
below the cooking surface and any combustible construction.
Rotisserie
A 6" (15.2 cm) minimum clearance is needed for the rotisserie
motor.
A grounded, 3-prong outlet located to the left of the grill is
required. See “Electrical Requirements” section.
5