Transcript
® 48" Commercial Style Dual Fuel Range with self-cleaning thermal/convection oven PRODUCT MODEL NUMBERS OVERALL DIMENSIONS KDRP487M NOTE: regulator located at center bottom of range. Gas supply: Use 3/4" rigid pipe gas supply line to the range location. A smaller size pipe on long runs may result in insufficient gas supply. With L.P. gas, piping or tubing size can be 1/2" minimum. If local codes permit, it is recommended that new flexible metal tubing, design-certified by AGA or CSA, 4-5 feet long, 5/8-inch I.D., be used for connecting the range to the rigid gas supply line. A 1/2" male pipe thread is needed for connection to pressure regulator female pipe threads. An individual manual shutoff valve must be located in the same room, but external to the range. Electrical: A four-wire or three-wire, single phase, 240-volt, 60-Hz, AC-only, electrical supply is required on a separate 50 amp circuit, fused on both sides of the line. A time-delay fuse or circuit breaker is recommended. 48" (121.9 cm) cooktop width 13-1/2" (34.3 cm) 49-1/2" (125.7 cm) overall height 36" (91.4 cm) cooktop height with feet loosened 3/4 turns 1/4" (6.4 mm) spacer 48" (121.9 cm) width 26-1/2" (67.3 cm) depth with control panel 48" (121.9 cm) range with all sealed burners shown CABINET OPENING DIMENSIONS 13" (33 cm) max. upper cabinet depth 18" (45.7 cm) upper cabinet to countertop 48" (121.9 cm) min. upper cabinet width For minimum clearance to top of range, see NOTE.* 12" (30.5 cm) min. clearance from both sides of range to side wall or other combustible material above cooking surface 48-1/4" (122.6 cm) opening width 8" (20.3 cm) 0" (0 cm) clearance from both sides and back of range to adjacent combustible construction below cooking surface 3" (7.6 cm) maximum gas line height *NOTE: 49" (124.5 cm) min. when bottom of wood or metal cabinet is protected by not less than 1/4" (0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper. gas line opening to be located in this area 40" (101.6 cm) 55" (139.7 cm) min. clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet. 5-1/2" (14 cm) 4" (10.2 cm) 3-1/2" (8.9 cm) maximum junction box height 20" (50.8 cm) 12" (30.5 cm) junction box to be located in this area Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. Ref. 8302571 12-07-04
