Transcript
(CU 10111C onto arm rum Р ГО Please read the following instructions and safety warnings carefully before use. For more exciting lonic Pro® products, visit www.ionicpro.com today. Now get ready to enjoy the many benefits of cleaner, fresher air! FEATURES Your lonic Pro® Mini ionic air purifier delivers cleaner, fresher, healthier air to your smaller indoor environments such as bathrooms, closets, pantries, places where pets dwell and other small areas in your home or office. e Reduces airborne allergens and irritants e Totally silent e No filters to replace e Easy to operate e Low power consumption Contemporary styling with built-in nightlight Perfect for bathrooms, closets, pantries, pet zones, home offices and other small areas OPERATING YOUR IONIC PRO® MINI IONIC AIR PURIFIER: Prior to Use 1. Ensure that the wire т 5 / = cleaning slide bar is _ TD. re in the “PARKED” position. - [== Ш O O 8 O 2. Open the front cover camp 7 by sliding the latch - | located on the o — backside, “OPEN” 3. Make sure that the collection blades are correctly installed 4. Close front cover. Make sure that door is fully closed and the door is securely attached. Use 1. Simply plug into a standard wall outlet (120v AC 60Hz). NOTE: Your lonic Pro® Mini ionic air purifier should NEVER be used with extension cords. 2. The lonic Pro® Mini ionic air purifier should immediately illuminate, and a gentle air flow should be detected. CLEANING Recommended cleaning of the collection blades is after every four to five days of use. Collection Blades 1. Remove the lonic Pro® о CED gw, © Mini ionic air purifier from - QE the wall to gain access : to the latch located on О © - Q the backside. 2. Open the front cover — = CAD © by sliding the latch - 1 located on the ; - Eo backside, “OPEN” 3. Detach the collection blades. 4. Use mild soap and water to clean the collection blades, then rinse and dry with a paper towel. 5. DO NOT INSTALL COLLECTION BLADES FOR 24 HOURS OR UNTIL COMPLETELY DRY. MAKE SURE THE UNIT 1S UNPLUGGED BEFORE INSTALLING BLADES. CLEANING (continued) Wires я ® e \ 1. Remove the lonic Pro O CUD ge, © Mini ionic air purifier = from the wall to gain = access to the latch o о | a MuYd located on the backside. by sliding the latch located on the backside, “OPEN” so that the wires are visible. 2. Open the front cover NOTE: Exposing your lonic Pro® Mini ionic air purifier to candles, oil lamps, fireplace soot, smoke or extremely dusty locations is not recommended and will require the collection blades to be cleaned after every exposure. 3. Locate the wire cleaning (fo MD yo © slide bar on the backside. = ——— — Slide the wire cleaning = BESA slide bar up and down, lo o é el two times. Inspect wires for dust, lint, and residue. Repeat as required. Return the wire cleaning slide bar to the “parked” position. 4. Close front cover. Ensure that the front cover latch on the backside is closed and the door is securely latched. HELPFUL TIPS: Remember to clean your lonic Pro® Mini ionic air purifier every week and anytime you hear your unit begin to make excessive noise. CAUTION: Risk of electrical shock. This product is not a toy and is not intended for use by children. For adult use only. SAFETY AND MAINTENANCE e Use only as described in this lonic Pro® Mini ionic air purifier leaflet. To reduce the risk of electric shock, do not attempt to service the product in any way other than in the manner described in the Cleaning and Maintenance section of this leaflet. Do not unscrew and open casing of the lonic Pro® Mini ionic air purifier. Attempting to the access internal circuitry will void the warranty and could cause serious personal injury to the user and/or result in considerable damage to the unit. * Do not place the lonic Pro® Mini ionic air purifier’s cord near a heated surface. e Always remove the unit from its power outlet by firmly holding and pulling gently. ¢ Use care when operating the lonic Pro® Mini ionic air purifier by keeping all fingers, body parts, hair, loose clothing and jewelry away from openings. * Do not touch the internal collection blades or ionizing wires, or any part of the unit with your fingers or with any object capable of conducting electricity. * Do not touch the unit or its plug when your hands are wet. ® Do not operate the unit if flammable or combustible vapors are present. The collection blades should be inspected frequently and cleaned regularly to prevent excessive accumulation that may result in an electrical flashover or a risk of fire. Always unplug the unit from outlet before cleaning the collection blades. This is an electrical appliance. Adult supervision is required when operating the unit in the presence of children. Do not operate the unit if the plug is damaged or appears damaged. Only qualified service personnel should ever replace or attempt to replace a damaged electrical plug. NEVER use this unit with an extension cord. Unit is designed for wall outlet use ONLY * The lonic Pro? Mini lonic Air Purifier operates at 120v AC 60Hz. e Use only indoors. e To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact qualified personnel to install the proper outlet. Do not alter the plug in any way. TROUBLESHOOTING Noise The unit may need to be cleaned more often if excessive hissing or “static” sounds are heard. Static may be caused by moisture. Some static or hissing sounds are normal. Wall Outlet If unit does not hold firmly to wall outlet, your electrical outlet may need servicing. Consult with a qualified electrician for assistance. Night Light If the night light does not illuminate, check power to the wall outlet. If power is okay, then internal protection fuse (non-replaceable) has blown and night light will not illuminate. Contact customer service for further assistance. lonic Pro, LLC Contact Info for Customer Service: PO. Box 3456 www.ionicpro.com IPMIN052208 800.875.8577 Los Angeles, CA 90078 © 2005 lonic Pro, LLC. All Rights Reserved. US Patent Nos. D495,042; 6,855,190. Chinese Patent No. ZL03353322.9 Additional patents pending worldwide.
