Download Harbor Freight Tools Swivel Handle for Wooden Dolly Product manual
Transcript
Swivel Handle For Wooden Dolly ( Works with Harbor Freight Tools SKU # 92486, 93888 and 38970 Furniture Dollys) 94354 ASSEMBLY & OPERATING INSTRUCTIONS 660 Lb. Towing Ability 3491 Mission Oaks Blvd., Camarillo, CA 93011 Visit our Web site at: http://www.harborfreight.com Copyright © 2006 by Harbor Freight Tools. All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For technical questions please call 1-800-444-3353 ASSEMBLY & OPERATING INSTRUCTIONS The Handle for Wooden Dolly is attached to a furniture dolly (not included) using the four screws included with this product. Position the Handle in the middle of the furniture dolly, as shown in Figure 2. Mark the placement for the screws. Use a small diameter drill bit (one smaller than the screws) to drill four pilot holes. Use a Philips Head screwdriver to thread the screw through the Handle and into the furniture dolly (not included), as shown in Figure 2. The Handle is adjustable from 27-1/2” to 38-1/4”. Remove the Adjusting Bolts, as shown in Figure 1, and move the handle to the desired length. Then insert the same bolts back into the handle and tighten them using a wrench. The Handle comes with a plastic Holding Bracket, as shown in Figure 2. After installing the Handle, mark the spot for the Holding Bracket. Drill pilot holes and screw the Bracket into the furniture dolly to secure it. Holding Bracket Figure 1 Mounting Screws Adjusting Bolts Figure 2 1. Read and fully understand this instruction sheet before using the Handle. 2. The maximum towing capacity is 660 LBS. Do not exceed this limit. 3. Always wear ANSI-approved safety goggles when working with tools and equipment. 4. Always keep arms, feet, legs, etc. out from under the furniture dolly. Children should always be kept at a safe distance. Never allow children to play with or ride on a dolly. 5. Make sure the Handle for the Wooden Dolly is securely connected to the furniture dolly before attempting to move any furniture. 6. The furniture dolly should only be used on a flat and level surface. Make sure the load is evenly distributed on the furniture dolly before moving it. SKU 94354 Page 2