Download Graco 313289S User's Manual

Transcript
Flush
5. Open recirculation valves (AC, AD) for respective
pump dispense side. Run pumps until the A and B
reservoirs are empty. Salvage the material in separate, clean containers.
AC
AD
AE
AF
AH
AJ
AD
r_312359_313289_6
AC
9. Close recirculation valves (AC, AD) and open mix
manifold valves (AH, AJ). Dispense fresh solvent
through mix manifold valves and out gun.
r_312359_313289_7
NOTE:
When priming or flushing the pumps, it is normal to get
cavitation or pump runaway alarms. Clear the alarms
, and press
again as necessary. These
alarms prevent excessive pump speeds that can damage pump packings.
6. Wipe the reservoirs clean, then add solvent to each.
Move circulation lines to waste containers.
7. Repeat Step 4 to flush through each side until clean
solvent exits recirculation hose.
8. Stop and move recirculation hoses back to reservoirs. Continue recirculating until machine is thoroughly flushed.
10. Close mix manifold valves (AH, AJ).
11. Slowly open sampling valves (AE, AF) to flush solvent through until clean. Close sampling valves.
Press
.
12. Follow Pressure Relief Procedure, page 12.
13. Remove pump fluid filters, if installed, and soak in
solvent. Clean and replace filter cap. Clean filter
o-rings and leave out to dry. Do not leave o-rings in
solvent.
14. Close main air valve (E).
NOTE:
Always leave some type of fluid, such as solvent or oil,
in the system to prevent scale build up. This build up
can flake off later. Do not use water.
313289S
17