Download Garmin Software Version 0857.09 Instruction Manual

3.12
TAWS-B ENABLE PROCEDURE
NOTE
The TAWS-B Enable card can only enable TAWS on one system (one
aircraft). A new TAWS Enable card must be used for each aircraft.
a. Remove power from the MFD and PFD by pulling the PFD and MFD circuit breakers.
b. Insert the TAWS Enable card, 010-00330-51 in the upper slot of the PFD.
c. While holding the ENT key on the PFD and MFD restore power to the displays.
d. When the words
displays, release the ENT key.
appear in the upper left corner of the
e. On the PFD, go to the System Upload page.
f.
Activate the cursor and use the small FMS knob to activate the drop down menu and
select CONFIGURATION FILES in the AIRFRAME field. Press ENT.
g. Use the small FMS knob to activate the drop down menu and select ENABLE TAWS
in the FILE field. Press ENT.
h. Verify there is a check mark in the box in the configuration column for AIRFRAME.
i.
Press the LOAD softkey.
j.
Monitor the status of the upload. When the upload is finished, Complete and Pass is
displayed. Press ENT.
k. De-activate the cursor.
l.
Power down the system and remove the TAWS-B Enable card from the PFD.
G1000 System Maintenance Manual - Hawker Beechcraft G58
190-01180-02
Page 3-23
Revision 3