Download Fujitsu ST3500 User's Guide
Transcript
Powering Up the Pen Tablet 2 Follow the procedure below to start the Stylistic 3500 pen tablet. Before you begin, confirm that the system is in the Off state. To do so, observe the Status display. If the Power icon is not visible in the Status display, the system is in the Off state or in Save-to-Disk mode and it is safe to perform this procedure. If the Power icon is visible (either blinking or on continuously), do not perform this procedure. See “System States” earlier in this chapter for details on operational modes represented by the Power icon. 1. Press the Power On/Suspend/Resume button to start the system. 2. Ensure that the battery pack in your pen tablet is sufficiently charged, or connect an external power source such as the AC adapter or auto adapter to your pen tablet. See “Status Display” in Chapter 1 to determine the percentage of charge represented by the Battery Gauge icon in the Status display. After performing system initialization, the system starts the operating system installed on the hard disk drive. Once the operating system is running, you can use the system. Shutting Down the System 2 Follow these steps to shut down and turn off your system: 1. If system operation has been suspended, resume system operation. See “Resuming System Operation” later in this chapter for details. 2. Save your work and close all running programs. 3. Choose Shut Down from the Windows (98, NT Workstation, or 2000) Start menu. 4. Carry out the Shut Down command. The system is now in the Off state. Powering Up the Pen Tablet 17