Transcript
Bravetti Power Mixer Optional Accessories for Model EP565/575 Stand & Bowl (EP565/575) Instructions for Use WARNING: To avoid injury when attaching the mixer to the stand or when inserting or removing beaters, dough hooks, whisk, hand blender or chopper, ALWAYS set the speed selector on “OFF” and unplug the appliance. IMPORTANT: Read all the “IMPORTANT SAFEGUARDS” and “INSTRUCTIONS FOR USE” included in your Bravetti Model EP565/575 Power Mixer “Use & Care Instructions” booklet before operating (using) the unit. Assembling Stand for Hand Mixer The stand comes in two pieces and requires a snap-in assembly. Before using your Bravetti Stand & Bowl, wash the bowl in warm, sudsy water. Rinse and dry. • Place the Bottom of the Stand (B) on a flat surface. • While holding the Mixer Shelf (A) push it down onto the Bottom of the Stand (B) so that the protruding pegs of the Mixer Shelf (A) slide down the side and eventually lock into the holes on the Bottom of the Stand (B). • Place the mixer on the Mixer Shelf by sliding the mixer forward into position so that the front of the mixer locks in place. • The mixer is placed in the upright position on the stand by pushing open the Locking flap (C) on the rear of stand and pulling the Mixer Shelf (A) backwards. • Place Beaters or Dough Hooks into beater receptacles while mixer is assembled onto Mixer Shelf in the upright position. For information or assistance: EURO-PRO Operating LLC Boston, MA 02465 Tel.: 1 (800) 798-7398 www.euro-pro.com