Download Avaya 1210 User Guide

Installing your Avaya 1210 IP Deskphone
1. Plug the headset cord into the headset jack on the back of the IP
Deskphone marked with the ) symbol.
Figure 3 on page 40 shows the connections on the back of the IP
Deskphone.
2. Thread the cord through the channel in the side of the foot stand.
3. Set up the headset according to the headset instructions.
Connecting the power
Your 1210 IP Deskphone supports AC power or Power over Ethernet
(PoE) options, including IEEE 802.3 standard power.
To use local AC power, you can order the optional AC adapter and
country-specific IEC cable separately. For AC power, use only the Avayaapproved Global Power Supply (NTYS17xxE6).
CAUTION
Use only the approved Avaya Global
Power Supply with your 1210 IP
Deskphone.
To use PoE, where power is delivered over the CAT5 cable, your
connected LAN must support PoE. If you use PoE, you do not require an
AC adapter.
1. Connect the DC barrel connector to the power jack on the back of the
IP Deskphone.
2. Thread the cable through the channel in the foot stand to secure the
cable.
3. Plug the country-specific IEC cable into the Global Power Supply,
and then plug the Global Power Supply into the nearest AC power
outlet.
42