Transcript
hotsoak 62 HOTSOAK SERIES Model # AI3AIR7236HS Deck Width 2” 36” 36” 71 1/4” Rough-In Plumbing Measurements 23 1/4” 21 3/4” 10 1/2” 20” 1 1/2” SPECIFICATIONS: General Specifications: Tub Size Bathing Well Shipping Weight Tub Weight Filled Tub Only Weight Gallons to Overflow 71 1/4” x 36” x 23 1/4” 181 cm x 91 cm x 59 cm 48 1/2” long 24” wide 21 3/4” interior depth 245 lbs. / 111 kg 868 lbs. / 394 kg 126 lbs. / 57 kg 90 gal. / 341 L Electrical Specifications: Pump Heater Requirements 1/15 HP; 1.3 AMP; 110V 1.5 kW; 12.5 AMP; 110V 20 AMP; 110V, separate circuit required protected w/ Class A GFCI This unit is not recommended for shower installations. Standard equipment: Aquatic Quality Features: - 1.5 kW Inline Maintenance Heater - Run-Dry Pump with 20-Minute Timer - 2 Circulation Portal Covers - Bath-side On/Off Electronic Button - “Quiet Pad” Anti-Vibration Pump Mount for Quiet Operation - Raised Seat - Slip Resistant Floor - 2 Arm Rests - Extra Deep and Long Bathing Well - Pre-leveled ABS Support Base - Heat-bent rigid PVC piping for optimum sanitary conditions - Durable, easy to clean, Lucite® Cast Acrylic Surface - available in 8 Standard No-Charge Colors UL & IAPMO Listed, Factory Tested Limited Lifetime Warranty optional equipment: Chromatherapy LED Lighting* Comfort Pillow - Oval or Rectangle • Bolt-On Grab Bar - White, Biscuit, Chrome, Polished Brass, Gold, Polished Nickel, Satin Nickel or Oil Rubbed Bronze • Lift & Turn Waste and Overflow - Chrome, Polished Brass, Gold, Polished Nickel, Satin Nickel or Oil Rubbed Bronze • Cable Drive Waste and Overflow - Chrome, Polished Brass, Gold, Polished Nickel, Satin Nickel, Oil Rubbed Bronze or Color Matched (Bone, White and Biscuit only) • Factory Installed Rigid ABS Tile Flange • Color Matched Acrylic Skirt • Premium colors • • All acrylic colors featured by Aquatic match the industry’s leading fixture manufacturers. *This whirlpool will need to be hard wired to the breaker box. Three outlets will be supplied on the whirlpool. Fax-On-Demand Document # 1237 The manufacturer accepts a 1/4” variance. There are variations on each tub and specifications are subject to change as we improve upon our product as required. The dimensions needed for site preparation and structure building should be measured from the tub; Aquatic Industries, Inc. assumes no responsibility for preparatory work. www.aquaticwhirlpools.com 800.555.5324 106 August 2008