Download Aiphone GT-HID User's Manual

HID Proximity Card Reader Module for GT Entrance Panel
- INSTRUCTIONS The GT-HID is an Access Control module for the GT Entrance Panel that contains an HID ProxPoint® Plus Card
Reader. This module installs into the entrance panel and cosmetically matches, so a separate card reader does not
need to be installed. The card reader provides electronic access to a building through the standard Access Control
system, which is not supplied by Aiphone.
INSTALLATION:
1. Install GT-HID card reader module in the GT entrance panel. (Install in a lower position for ease of access).
2. GT-HID will snap into the GF-2F or GF-3F frame.
3. Secure wire connections as shown on wiring chart.
4. Cut any unused wire so that bare wires are not exposed.
5. Refer to standard GT Installation Manual for complete system information. No additional information pertaining to
the Access Control system is provided by Aiphone.
GT-HID
(front view)
GT-HID
(back view)
LED indicator
Connecting the Reader to the Host:
Connect the reader to the host according to the
wiring table below and the host installation guide.
Wire Color
Red
Black
Violet
Green
White
Drain
Orange
Brown
Yellow
Blue
18" pigtail cable
To Host
Wiegand
+ DC
Ground
--Data0
Data1
Shield Ground
Green LED
Red LED
Beeper
Hold
Page 1
TYPICAL LAYOUTS:
Video with 4 buttons and
card reader
1
2
3
1
2
3
4
5
6
4
5
6
7
8
9
7
8
9
*
0
#
*
0
#
Digital audio with card reader
Audio with 4 buttons
and card reader
Digital video with card
reader
TESTING AND OPERATION:
When power is applied to the reader, the LED will flash green three (3) times while the
beeper beeps simultaneously. The LED will then turn red. This indicates that the
microcontroller is operating properly.
Present an ID card to the reader. (Hold card directly in front of reader module.) The LED
will momentarily turn green while the beeper beeps once, indicating that the card was
read successfully.
SPECIFICATIONS:
Model #:
Power Source:
Absolute Max. Voltage:
Peak Current:
Avg. Current 5V or 12V:
Terminations:
Wiring Distance:
Dimensions (H x W x D):
Operating Temperature:
HID 6005B
5.0 – 16.0 VDC
18 VDC
80 mA
20 mA
Color-coded pre-wired pigtails
500'
3 ¾” x 4 3/16" x 1 7/8"
-10° ~ 60° C / 14° ~ 140° F
FCC WARNING:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may cause undesired operation.
For proper regulatory compliance, the drain wire should be disconnected at the
power supply end of the cable.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
The Reader is intended to be powered from a limited power source output of a
previously certified power supply.
Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005
TOLL FREE TECHNICAL SUPPORT: (800) 692-0200
(425) 455-0510
E-MAIL: [email protected]
FAX (425) 455-0071
GT-HID Instr.
0912PHJD