Download Plados MIXOLD

Sinks
Sinks
UNDERMOUNT INSTALLATION
Solution A
Solution B
Sink edge is flush with the worktop
The sink edge is under the
worktop
(Recommended solution)*
Worktop
Worktop
Worktop
Sink
Sink
Sink
This solution:
• Exalts the aesthetic aspect
• Helps to clean the sink
• Optimizes the hygiene
*
Solution C
The sink edge is partially
visible
This solution:
• Eases the installation
• Helps to clean the sink
This solution:
• Helps to clean the sink
• Optimizes the hygiene
The worktop hole cut-out supplied on demand is intended for this solution only
UNDER-MOUNT
WORKTOP IN COMPOUND MATERIAL (LIKE CORIAN)
ANCHORAGE
AXLE BOX
WORKTOP IN MARBLE/
GRANIT
SEAL
SEAL
SINK
FIXING BRACKET
SCREW
SINK
FIXING BRACKET
SCREW
ATTENTION!
FIXING BRACKET
In order to help marble cutters, on demand we
can send by email the geometric scheme in .dfx
or .dwg formats to cut the worktop. Moreover,
always on demand, we can also send by priority
mail the paper cut-out. All the cutouts can be
easily downloaded by Plados website. In all the
supplied schemes the sink edge is flush with the
worktop (solution A)
FLUSH-MOUNT
SINK
WORKTOP IN MARBLE/
GRANIT
All Plados sinks can be installed in
the normal way, wich is built-in in
modular kitchens worktops, or they
can be installed undermounted.
For undermounting installation,
please order the suitable installation
kit (code GANCIST10)
15°
WORKTOP IN COMPOUND MATERIAL
(LIKE CORIAN)
SINK
SINK
Sinks for flush-mount are supplied on
demand.
Ask for details before ordering
SEAL
SEAL
CORRECT PROCEDURE TO DRILL THE SINK
Plados sinks are provided with pre-punched hole (picture A) placed
on both sides in order to choose where to place the mixer tap and
the suitable accessories.
NOTE
In order to avoid any possible damage to the sink, we strictly recommend to drill these pre-punched holes using a Ø35-37 mm drill following the procedure shown in pictures B and C
On request Plados supplies either the complete drilling kit (code
KITFRESA) composed by the drill plus the joint, or just the drill (code
FRESA). Drills are lon lasting as they are diamond coated. SEE pictures
D and E.
Code
FRESA
Fig. E - Diamond coated drill for Ø3537 mm hole
Code
KITFRESA
Fig. A - Pre-punched holes in plados sinks
Fig. B - Place the tool on the pre-punched hole
Fig. C - Drill the hole
Fig. D - Kit composed by
joint+drill
29