Transcript
Active Holder for Fixed Installation The neatest installation You can choose to use the holder as an active holder only for charging, or to connect an adapter to the Molex connector for additional features. Then you can use the holder also for power supply of a GPS receiver, data transfer or other own solutions. (Support for TX/RX signal in the device is required.) The holder is attached onto a tilt swivel so it can be adjusted in order to avoid light reflection. Attach onto the ProClip Mounting Platform. Tel +46 (0)505 109 00 Fax +46 (0)505 445 72 Molex Adapter System Molex adapter system has overmoulded connectors and a buit-in resettable fuse (2 A). The box has protection against peaks and overload. The product is CE and E approved. Connect the power cable with a 2 A fuse. 5 Volt out. 2 A charger. 12/24 Volt. Professional installation recommended. For a complete range, please visit www.brodit.se Gesällvägen 8 546 34 Karlsborg, Sweden [email protected] www.brodit.se 234492 908 An active holder with a straight cable with open end for fixed installation and a cable with Molex adapter system. The cables are to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior.