Download XciteRC 13003110
Transcript
Troubleshooting Problem Possible cause Solution Turn on the helicopter after binding succasafully,the propeller rotate constantly but the hellcoptar can not take off. Low charge in aircraft batteries or main gear loose. Replace and charge the batteries ;press the spindle with gear tightly. Helicopter vibrates os shakes in flight. Damaged rotor blades and lateral axis blade grips too tight causing the movement of the main rotor isn´t smooth. Change the main rotor blades, and lateral axis.; loosen the bllade grips properly. Main rotor blades are shaking in flying. Lateral axis is bent; lateral axis screw is not tight. There are some debris in the servo, causing shakes, The loose between the swash plates. Deformed or damaged tail rotor blades. Replace the lateral axis. Tighten the lateral axis screw. Change the bearing. Remove he servo and clear debris. Compress the swash plates. Change tail rotor blades. Helicopter is out of control when it takes off. The helicopter isn´t maintained static level when it is binding. Rebind the TX and RX correctly. The sound of the main rotor becomes smaller. Low battery voltage of helicopter. Charge the battery or change a fully charged battery. Helicopter has no reaction or can not fly smoothly. Failure to binding. Rebind the helicopter and transmitter, make sure you place the helicopter static level next to the transmitter. EN Receive board Interface Diagram Main Motor 13001000 XciteRC Flybarless Trainer 245 13001000-Flybarless-Trainer-245-Anleitung.indd 19 Tail motor Aileron Elevator 19 24.10.2013 14:34:06
This document in other languages
- français: XciteRC 13003110
- Deutsch: XciteRC 13003110