Transcript
Installation and Assembly - Armor Lock Plus™ Security Cable with lock Model: ACC020 IMPORTANT! Read entire instruction sheet before you start installation and assembly. Before you start check the parts list below to make sure all of the parts shown are included. Parts List Description A cable assembly Qty. 1 Part Number 600-0055 Note: Actual parts may appear slightly different than illustrated. 1 A Wrap cable assembly around extension column and insert lock mechanism through cable loop as shown. EXTENSION COLUMN LOCK MECHANISM CABLE LOOP PROJECTOR MOUNT AND PROJECTOR MAY APPEAR DIFFERENT THAN ILLUSTRATED. 2 Insert key into lock mechanism and set to open position by pushing in key and rotating until hooks are in open position as shown in figure 2.1. Note: Key is not removable in open position. Wrap cable around extension column a few times to reduce slack if needed as shown in figure 2.2. Insert hooks of lock mechanism into slot on projector, then push in key and turn to lock. fig. 2.2 fig. 2.1 HOOKS IN OPEN POSITION SLOT 1 of 1 Visit the Peerless Web Site at www.peerlessmounts.com ISSUED: 09-30-02 SHEET #: 055-9109-7 03-11-08 For customer care call 1-800-729-0307 or 708-865-8870. © 2007, Peerless Industries, Inc. All rights reserved. All other brand and product names are trademarks or registered trademarks of their respective owners.
