Transcript
Addendum to the X6DH8-XB/X6DHE-XB motherboard Attention!! Important Notice!! (Read the information listed below before using this product.) PLLSEL Select (Memory Speed Select): Jumpers JM1/JM2 (PLLSEL Select): These jumpers allow the user to select PLLSEL (Memory Speed). Make sure that the jumper settings are set correctly according to your memory speed before you power on the system. (*Warning!! If these jumpers are not set correctly according to your memory speed, video display failure may occur!!!) (*Note: the default setting is “Closed” for both jumpers to enable DDR Memory at 333MHz. However, if your memory speed is 266MHz, please make sure to set both jumpers to “Open”.) PLLSEL Select Jumper Settings (JM1/JM2) DDR JM1 JM2 *333 MHz Closed Closed 266MHz Open Open (*Default:Closed-333MHz) USB 0/1 Fan7 J24 PW SMB PWR2 24-Pin ATX PWR 4-Pin PWR1 PWR DIMM 1A (Bank 1) Fan1 Fan6 Fan5 8-pin PWR PW3 J25 JF1 KB/ Mouse JP12 JM1/JM2 (PLLSEL: Memroy Speed Select) LE1 J P 1 3 JPF1 DIMM 3B (Bank 3) DIMM 4A (Bank 4) DIMM 4B (Bank 4) CPU 2 VGA JPL1 GLAN CTLR Slot4 SI/O PCI-E x4 JWD1 PCI-X 133 MHz PXH PCI-X 100 MHz PCI-X 100 MHz ZCR Slot3 PCI-X133 MHz Slot2 PCI-X100 MHz Slot1 PCI-X100 MHz JWOL1 JWOR1 South JBT1 Bridge BIOS JPA1 7902 PXH GLAN CTLR IPMI ICH5R USB4 SCSI Battery CTRL SMB JPA2 JPA3 USB2/3 Ultra 320 SCSI CH B SPKR SATA0 SATA1 JL1 IDE1 Slot7 RAGEXL Slot6 VGA Ctrl Slot5 J27 Fan8 Floppy JK1 JPG1 JPL2 JCOM2 JM1 IDE2 E7520 Lindenhurst North Bridge GLAN2 Ultra 320 SCSI CH A GLAN1 Fan3 X6DH8-XB JM2 ® PLLSEL SUPER Fan2 JP15 DIMM 3A (Bank 3) JAR1 JOH1 CPU 1 DIMM 2B (Bank 2) COM1 JD1 DIMM 1B (Bank 1) DIMM 2A (Bank 2) Fan4 Add-X6DH8-XB-12/10/04
