Download Mobotix D24M-Sec

70/148
D24M Camera Manual: INSTALLATION
2.7.3 Procedure
1. Prepare the network connection: Run the network cable above the suspended
ceiling and ensure that enough cable slack is available.
2. Cut a hole for installation: Cut a round hole for camera installation (e.g. with a 150 mm hole saw). Use the
supplied cutting template of the In-Ceiling Set (fold-out
at the end of the manual).
3. Remove the camera outer shell: Remove all four Allen
screws using the supplied Allen wrench and lift off the
outer shell (not mounted upon delivery).
4. Remove the mounting ring: Separate the mounting
ring from the camera housing. This ring is not required
to mount the camera in the In-Ceiling Set.
5. Place the camera in the In-Ceiling Set: The dovetail
guides at the back of the camera housing fit exactly
into the openings of the In-Ceiling mounting ring. To
make the camera even more secure (e.g. for mobile
use), push the four clamps (item 3.4) into the square
notches above the dovetail guides until you hear them
click into place.
6. Connect the cable: Connect the on-site network cable to
the camera network cable using a standard connector.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]