Download Panasonic PT-DW530E data projector

About Your Projector
Remote control
JJTop view
Press the tab and lift up the
cover.
Insert the batteries according to
the polarity diagram indicated
inside. (insert the
side first).
Remove the batteries in the
reverse order to setting.
JJFront view
Remote control indicator
Flashes by pressing any buttons
Switch between stand-by mode and projection mode.
These buttons select the RGB1, RGB2, DVI-D, VIDEO, S-VIDEO and HDMI terminals.
(Æpage 37)
Displays and clears the main menu, and returns to the previous menu when the menu
is displayed.(Æpage 40)
Capture the projected image as a frozen picture. (Æpage 37)
Restores the default factory setting. (Æpage 40)
Assign the frequently use functions from options for shortcut. (Æpage 38)
Specifies the ID of the remote control. (Æpage 22)
Makes the remote control available to control any ID projectors. (Æpage 22)
Pressing this button while projecting an image automatically corrects the picture
positioning on the screen. While the auto setup feature is active, a message
“PROGRESS” appears on the screen. (Æpage 38)
Navigate through the menu items with ▲▼◄►, and activate them with the <ENTER>
button. (Æpage 40)
Turn off the projection temporarily. (Æpage 37)
Opens [ECO MANAGEMENT] menu. (Æpage 38)
Control to adjust the volume of the speaker. (Æpage 39)
You can attach
a favourite
strap onto the
remote control.
Attention
zz Do not drop the remote control.
zz Avoid contact with liquids or moisture.
zz Do not attempt to modify or disassemble the remote control.
zz Do not let strong light shine onto the signal receptor. The remote control may malfunction under strong light such as
fluorescent.
Note
zz The remote control can be used within a distance of about 30 m if pointed directly at the remote control receiver. The
remote control can control at angles of up to ± 15 °C vertically and ± 30 °C horizontally, but the effective control range may
be reduced.
zz If there are any obstacles between the remote control and the remote control signal receptor, the remote control may not
operate correctly.
The signal will be reflected off the screen. The operating range may differ due to the screen material.
zz When the projector receives a signal from the remote control, the Power indicator will flash.
ENGLISH - 19
Preparation
Remote control
signal emitters
Installing/removing batteries