Download Chief Suspended Ceiling Kit

INSTALLATION INSTRUCTIONS
A
D
D
E
N
D
U
M
Istruzioni di installazione
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Installatie-instructies
Instructions d´installation
CMS440P
CMS445P
Above-Tile and Ceiling Tile Kits
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
CMS440P / CMS445P
CMS440P / CMS445P
Installation Instructions
DISCLAIMER
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual
accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or
variations, nor does it provide for every possible contingency in connection with the installation or use of this product. The
information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no
representation of warranty, expressed or implied, regarding the information contained herein. Milestone assumes no responsibility
for accuracy, completeness or sufficiency of the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
LEGEND
2
Tighten Fastener
Pencil Mark
Apretar elemento de fijación
Marcar con lápiz
Befestigungsteil festziehen
Stiftmarkierung
Apertar fixador
Marcar com lápis
Serrare il fissaggio
Segno a matita
Bevestiging vastdraaien
Potloodmerkteken
Serrez les fixations
Marquage au crayon
Loosen Fastener
Drill Hole
Aflojar elemento de fijación
Perforar
Befestigungsteil lösen
Bohrloch
Desapertar fixador
Fazer furo
Allentare il fissaggio
Praticare un foro
Bevestiging losdraaien
Gat boren
Desserrez les fixations
Percez un trou
Phillips Screwdriver
Adjust
Destornillador Phillips
Ajustar
Kreuzschlitzschraubendreher
Einstellen
Chave de fendas Phillips
Ajustar
Cacciavite a stella
Regolare
Kruiskopschroevendraaier
Afstellen
Tournevis à pointe cruciforme
Ajuster
Installation Instructions
CMS440P / CMS445P
TOOLS REQUIRED FOR INSTALLATION
ADDITIONAL PARTS
Grounding screw and washer installed at factory
(See Figures 3 and 6)
10-32 x 3/8"
#10
Earthing symbol IEC 60418 No. 5019
affixed adjacent to grounding terminal.
A (1)
[CMS440P only]
B (1)
6-32 x 1/2"
[CMS440P only]
3
CMS440P / CMS445P
Installation Instructions
WARNING: IMPROPER INSTALLATION CAN RESULT IN
3.
Loosen two Phillips head screws on the electrical box.
4.
Remove electrical box cover. (See Figure 3)
DEATH OR SERIOUS PERSONAL INJURY! This accessory
should be installed by qualified personnel.
3
IMPORTANT ! : In addition to the CMS440 and CMS445
Electrical box
cover
x2
installation instructions accompanying the products, the
following steps must also be taken when installing the
CMS440P and CMS445P.
4
The CMS440P/CMS445P must be connected to a 15 Amp
branch circuit.
CMS440P
1.
Cut a hole in the ceiling tile around the outlet side of the
electrical box so that the ceiling tile will fit over the
CMS440P. (See Figure 1)
Figure 3
WARNING: IMPROPER WIRING CAN LEAD TO DEATH
OR SEVERE PERSONAL INJURY! Grounding must be
installed by qualified personnel using a UL Recognized No.
12AWG Green grounding wire connected to grounding lug on
box.
1
Cut opening in ceiling
tile around outlet side
of electrical box.
WARNING: ELECTRICAL SHOCK HAZARD! Turn off
power to device before performing service.
Grounding Lug Location
Figure 1
2.
Attach face plate (A) using one 6-32 x 1/2" Phillips flat head
screw (B) after the CMS440P has been installed.
(A)
Green Grounding
Wire
2
(B) x 1
Figure 4
5.
Figure 2
4
Wire the CMS440P as required.
Installation Instructions
CMS440P / CMS445P
6.
Replace the electrical box cover. (See Figure 5)
7.
Tighten two Phillips head screws in electrical box cover.
WARNING: ELECTRICAL SHOCK HAZARD! Turn off
power to device before performing service.
7
Grounding Lug Location
x2
6
Green Grounding
Wire
Figure 7
Figure 5
CMS445P
1.
Loosen two Phillips head screws on the electrical box.
2.
Remove electrical box cover. (See Figure 6)
3.
Wire the CMS445P as required.
4.
Replace the electrical box cover. (See Figure 8)
5.
Tighten two Phillips head screws in electrical box cover.
Electrical box
cover
1
Electrical box
cover
x2
5
x2
4
2
Figure 6
Figure 8
WARNING: IMPROPER WIRING CAN LEAD TO DEATH
OR SEVERE PERSONAL INJURY! Grounding must be
installed by qualified personnel using a UL Recognized No.
12AWG Green grounding wire connected to grounding lug on
box.
5
CMS440P / CMS445P
6
Installation Instructions
Installation Instructions
CMS440P / CMS445P
7
CMS440P / CMS445P
Installation Instructions
USA/International
Europe
Chief Manufacturing, a products division
of Milestone AV Technologies
Asia Pacific
8803-000125 Rev01
2011 Milestone AV Technologies, a
Duchossois Group Company
www.chiefmfg.com
10/11
A
P
F
A
P
F
A
8401 Eagle Creek Parkway, Savage, MN 55378
800.582.6480 / 952.894.6280
877.894.6918 / 952.894.6918
Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands
+31 (0)40 2668620
+31 (0)40 2668615
Office No. 1 on 12/F, Shatin Galleria
18-24 Shan Mei Street
Fotan, Shatin, Hong Kong
P 852 2145 4099
F 852 2145 4477