Download Atdec VF-WD flat panel wall mount
Transcript
Installation Instructions Component Checklist Component Checklist IMPORTANT: Ensure you have received all parts against the component checklist prior to installing. Visidec Focus Wall Direct supports a maximum weight of 8kgs (17.5lbs) Bits Bag Wall Direct Assembly 5mm Allen Key 50mm Screw (x2) Wall Plug (x2) Mounting Fasteners M4x10mm Screw (x4) M4x12mm Screw (x4) M4x16mm Screw (x4) TOOLS REQUIRED: l Power Drill l 5.5mm (1/4”) Drill Bit l 8mm (5/16”) Drill Bit l Phillips Head Screwdriver NOTE: This product is designed to support a flat panel monitor in a noninteractive environment. i.e. It should not be used in a situation where the display’s position will be frequently changed. a Component Checklist Disassemble Step 1 Using the supplied Allen Key, remove the bottom screw. Step 2 Separate the two components. B Component Checklist Attach Base to Wall Masonry Wall 8mm (5/16”) hole Tip: Use a Spirit Level to ensure this surface is horizontal. Timber Stud Wall OR 5.5mm (1/4”) hole 50mm Screw Tip: Use a Spirit Level to ensure this surface is horizontal. 50mm Screw Wall Plug Timber Stud D Attach Head to Display OR 75mm (3”) 75mm (3”) M4 screw 75x75mm VESA E 100mm (4”) 100mm (4”) M4 screw 100x100mm VESA Attach Display to Wall Step 1 Position the Display & Bracket over the Base. Step 2 Close the two halves of the Bracket around the Base by firstly positioning the top half and then the bottom half. 1 2 Step 3 Reassemble the Wall Direct Assembly ensuring the weight of the display is supported until the screw is tightened. WARNING: Do not overtighten. Tip: This step can be made easier by using two people. F Adjust Display Position Step 1 Adjust the display to the desired viewing angle then lock it in place by tightening the tilt screw in the direction shown. Tighten WARNING: Do not overtighten. Step 2 Adjust the display’s position between landscape and portrait. The display can rotate through +/-95º. +/-95º NOTE: Screen does not rotate 360° No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 18.01.08 ©