Download Supermicro SuperServer 6026TT-BTF

SUPERSERVER 6026TT-BT(R)F/BIBX(R)F/BIBQ(R)F User's Manual
1-2
Serverboard Features
At the heart of the SuperServer 6026TT are four X8DTT-F/X8DTT-IBXF/X8DTTIBQF dual processor serverboards, which are based on Intel's 5520 (North Bridge)
+ ICH10R (South Bridge) chipset. (For OEM only, the Intel 5500 is also available
for the North Bridge portion of the chipset.) Below are the main features of the
serverboards. Note that the features on each board are quadrupled for the server,
which includes four nodes.
Processors
Each X8DTT-F/X8DTT-IBXF/X8DTT-IBQF supports two Intel® 5500 Series processors in LGA1366 sockets. Please refer to our web site for a complete listing of
supported processors (www.supermicro.com).
Memory
Each X8DTT-F/X8DTT-IBXF/X8DTT-IBQF has twelve 240-pin DIMM sockets that
can support up to 48 GB of registered ECC DDR3-1333/1066/800 SDRAM (192
GB for the system). See Chapter 5 Section 6 for more details on installing memory
into the system.
Serial ATA
The South Bridge (ICH10R) of the chipset includes a Serial ATA controller for six
Gb/s SATA drives. The hot-swappable SATA drives are connected to a backplane
that provides power, bus termination and configuration settings. RAID 0, 1, 10 and
5 are supported. Refer to the support area of our web site for procedures on setting up RAID on your system.
PCI Expansion Slots
Each X8DTT-F/X8DTT-IBXF/X8DTT-IBQF board has one PCI Express 2.0 x16 slot,
so four PCI Express 2.0 x16 slots (for low-profile expansion cards) are provided
in the server. In the 6026TT-BT(R)F/BIBX(R)F/BIBQ(R)F server configuration, riser
cards have been pre-installed to support low-profile add-on cards.
Ethernet Ports
An Intel® network controller is integrated into each of the serverboards to support
two Gigabit LAN ports (100/1000Base-T/1000BaseTX, RJ45 output).
1-2