Download Craftsman 917.20383 Operator`s manual
Transcript
TROUBLESHOOTING CHART: See appropriate section in manual unless directed to Sears service center PROBLEM Mower blades will not rotate POOr grass discharge Headlight(s) not working (if so equipped) Battery will not charge CAUSE CORRECTION 1 Obstruction 2 Worn/damaged in clutch 3 Frozen 4 Frozen 1 Engine 2 Travel 3 4 mechanism. 1 Remove obstruction. 2 Replace mower idler pulley. 3 Replace idler pulley. blade mandrel. 4 Contact a Sears qualified service speed too slow. 1 Place throttle position. 2 Shift to slower Wet grass. 3 Allow grass Mower 4 Level mower 5 Check tires for proper 6 Replace/sharpen blade bolt. mower drive belt speed too fast. deck not level. tire air pressure. drive belt. or other center. control in "FAST" speed. to dry before mowing deck. 5 Low/uneven 6 Worn, 7 Buildup of grass, leaves and trash under mower, 7 Clean underside housing. 8 Mower drive belt worn. 8 Replace mower drive belt. 9 Blades improperly 9 Reinstall blades sharp edge down bent or loose blade. blades installed. used. 10 PSI. blade. Tighten of mower 10 Improper 11 Clogged mower deck vent holes 11 from buildup of grass, leaves, and trash around mandrels. Clean around mandrels open vent holes. 1 Light switch 1 Turn light switch "ON". 2 Bulb(s) 2 Replace or lamp(s). 3 Faulty light switch. 3 Check/replace 4 Loose or damaged 4 Check wiring 5 Blown fuse. 5 Replace fuse. 1 Bad battery 1 Replace battery. 2 Poor cable 2 Check/clean 3 Faulty regulator 3 Replace regulator. 4 Faulty alternator. 4 Replace alternator. is "OFF". or lamp(s) burned out. wiring. cell(s). connections. (if so equipped). 31 Replace with blades this manual. bulb(s) listed in to light switch. and connections. all connections.
This document in other languages
- español: Craftsman 917.20383