Download Sharp CD-CH1000 Service manual
Transcript
Reassembly 1. Use bolts with heads removed, or a similar item as temporary alignment pins and install into 2 center holes on ends. 2. Install a new oil reservoir gasket onto bottom of crankcase using alignment pins. Notched side of gasket must be towards flywheel. 3. Install oil reservoir onto crankcase and temporary alignment pins. Flywheel side is indicated on cover. Install and finger tighten screws. Remove alignment pins and install remaining screws. Torque screws in sequence shown to 24.4 N·m (216 in. lb.). Check Crankshaft End Play Set engine on base and use a dial indicator to check crankshaft end play to 0.30/1.50 mm (0.011/0.059 in.). Breather Components Used on Serial No. 37070xxxxx and Below Breather Fastener Torque Sequence A 1 3 Used on Serial No. 37071xxxxx and Higher A B C D E B C 2 4 D F H Filter must Not Extend Above Casting G D H G D A A I SECTION A-A I A Breather Hose B Flange Nuts C Breather D Gasket E Screw F Baffle G Filter H Adapter I Studs Install Breather Assembly 1. Make sure sealing surfaces of crankcase and breather cover are clean and free of any nicks or burrs. Do not scrape surfaces, as this could result in leakage. Install breather mounting studs into crankcase if removed during disassembly. 2. Install breather chamber gasket as shown. Assemble and install breather assembly components as illustrated. Make sure filter does not extend above top surface and all parts are properly aligned. 3. Install M5 nuts onto studs, then torque using sequence shown to 5.7 N·m (51 in. lb.). 4. Lightly oil lower end of breather hose and install into hole in breather assembly. Cover should be situated between 2 raised rings of hose. 62 690 01 Rev. C KohlerEngines.com 63