1
Download Monogram ZV950 Owner`s manual
Transcript
The Problem Solver Stainless Questions Use this prob#m solver! ? PROBLEM POSSIBLE FAN DOES NOT OPERATE WHEN THE SWITCH IS ON * A fl_se may be blown reset circuit breaker. FAN FAILS TO CIRCULATE AIR * Fan * Excessively the FAN OPERATES BUT MOVES AIR SLOWER THAN NORMAL * Check correct FAN KEEPS GOING OFF AND ON * The motor be harmful striking soiled hood the or a circuit hood filter breaker tripped. Replace fllse or shell. shoukt be checked and corrected beffne again. to be sure the filter is clean. If replacing the problem, call fin service. the filter does not is probably overbearing and turning itself of I_ This can to the motor. Check to be sure the filter is clean. If off and on cycling CLEAN FILTER LIGHT IS ON OR BLINKING Hood CAUSE blade using Steel continues, call f_n service. The filters have been in place fin 30 hours of "on" time. Remove the filters, clean if necessary and replace them. Make sure they are correctly seated in the filter channels. Adjust as necessary until the red signal light stops blinking. See the Metal ,_easefilter/ Clean filter l_'ht section.
