Download AUDIOLINE TEL28 Operating instructions

- Commissioning 3
Commissioning
3.1
Safety information
NOTE! Before commissioning, it is essential that you read the general information
at the beginning of this manual.
3.2
The
one
one
one
one
Check contents of pack
following items are supplied:
telephone base
telephone connection cable
desk adapter
battery type AAA
3.3
one telephone receiver
one spiral cable
one Operating Manual
Fitting the battery
Before connecting your new telephone to the telephone network, the battery
should be fitted. Please always use a type AAA alkaline battery. The battery is
required for the display, the handsfree feature and other functions of the
telephone. Before installing or changing the battery, make sure that the telephone
is not connected to the telephone network.
Note: No messages will be shown in the display if a battery is not fitted.
1.
2.
3.
4.
5.
Make sure that the telephone is not connected to the telephone network.
The battery compartment is to be found on the underside of your telephone.
Open the battery compartment with a small screwdriver or a pointed object.
Insert the battery, ensuring that the polarity is correct.
Close the battery compartment.
The battery should be changed when the display can no longer be read properly.
If the battery is completely discharged, then you could lose stored telephone
numbers.
3.4
Connecting the telephone receiver
After unpacking your telephone, you must first connect the telephone receiver to
the base unit. First take the short end of the spiral cable and plug it into the
socket at the bottom of the receiver. Turn the telephone over and plug the long
end of the siral cable into the socket marked
cable channel to the outside.
20
. Feed the cable through the