Download Universal Laser Systems VL-300 Specifications
Transcript
Printer Driver Controls CORK RASTER ENGRAVING LASER WATTAGE 10 25 30 35 40 45 50 VECTOR ENGRAVING LASER WATTAGE 10 25 30 35 40 45 50 VECTOR CUTTING LASER WATTAGE 10 25 30 35 40 45 50 POWER 80 SPEED 30 PPI 500 PASS 1 DEPTH .010” 80 80 80 80 80 80 50 60 70 80 90 100 500 500 500 500 500 500 1 1 1 1 1 1 .010” .010” .010” .010” .010” .010” POWER 20 SPEED 4.0 PPI 500 PASS 1 DEPTH .010” 12 10 9 8 7 6 4.0 4.0 4.0 4.0 4.0 4.0 500 500 500 500 500 500 1 1 1 1 1 1 .010” .010” .010” .010” .010” .010” POWER 100 SPEED 1.6 PPI 100 PASS 1 DEPTH .060” 60 50 43 38 33 30 1.6 1.6 1.6 1.6 1.6 1.6 100 100 100 100 100 100 1 1 1 1 1 1 .060” .060” .060” .060” .060” .060” COMMENTS Cork is not very popular for engraving but it does engrave and cut nicely. Cork is mainly used for making gaskets by vector cutting the gasket patterns. LASER CUTTING THIS MATERIAL CAN CAUSE FLAMING AND SPARKING. Use caution when attempting to cut this material. It would be better to use a longer focal length lens to prevent the lens from being damaged during processing. NEVER leave the machine unattended while processing any material. Damages caused by processing any material WILL NOT be covered under warranty. Section 3-11