Download Scotsman CSW45 Specifications

Transcript
CSW45
Drain Pump Kit
1. Remove rear cover.
2. Remove old drain tube.
Pump, View from
Front of Cabinet
3. Install new drain tube to bin (use old clamp).
Pump
Mounting Tab
4. Install drain pump into machine. Carefully slide in
aligning the tab on the pump to the rectangular slot
in the unit base.
Vent Tube
5. Attach bin drain tube from bin to pump.
6. Connect vent tube to vent connection on pump.
Route vent up through the rear cover. Secure vent
tube to back of ice machine using three clamps and
screws from the kit.
7. Route pump outlet tube to household drain.
8. Power cord from ice machine must be plugged
into pump. Coil up and tape power cord together,
insert between compressor and drain pump. Plug the
power cord into the pump.
9. Line up the two screws at the rear of the pump
and secure the pump using two screws from the kit.
10. Install rear cover.
11. Connect power cord (pump’s) into the electrical
power supply. This must be a grounded circuit that
conforms to the National Electrical Code and all local
codes and ordinances.
July 1999
Page 9
Discharge
Hose
Pump
Mounting
Screws