Download Energic Plus MVM User`s manual

Battery charger MVM
USER'S MANUAL
MAIN SUPPLY VOLTAGE PRESET
Attention: These settings can be done by qualified personnel only.
For more information please contact the manufacturer.
The charger is set by default in position 2 (input voltage 240 Vac). If the input voltage is
different, the output current may change. It’s possible to adjust the charge current by
following these steps:
•
•
•
•
•
•
•
Disconnect the charger from main supply and battery;
Open the cabinet;
Find the plugs for input voltage setting;
Disconnect the wire A from the original plug;
Connect the wire A to the correct position (220, 230, 240 or 250 Vac);
Close the cabinet;
Connect the charger to main supply.
POSITION
VOLTAGE
4
250
3
240
2
230
1
220
__________________________________________________________________________________________________________________________________________________
Code: OWM-MVM-261006
Page 8/9