Download ViewSonic VG710s Service manual

Step 5. Let VG710 enter “Burn In Mode” (Refer to Chapter III-3. Hot Keys for Function Controls). Unplug and re-plug the
power cord of the monitor. The corrective serial number will show on the screen.
Step 6. Checking Method:
- Execute the DDC Key In program and select “R/r - Reading mode” in Step 2.
- Use barcode reader to scan the barcode of the monitor. If the DDC is correct, the “Send VGA” and “Send DFP” will
show “Check Pass!” message.
Confidential - Do Not Copy
ViewSonic Corporation
35
VG710b/s-1