Download Ryobi RY52014 Operator`s manual

Transcript
OPERATION
POSITION FOR STARTING
PRIMER BULB
See Figure 9.
Lay the pruner on the ground and ensure that no objects or
obstructions are in the immediate vicinity. Make sure nothing
can come in contact with the bar and chain.
STARTER GRIP
ENGINE
SWITCH
STARTING
INSTRUCTION
LABEL
Fig. 9
STARTING AND STOPPING
See Figures 10 - 12.
TO START A COLD ENGINE:
DO NOT squeeze the throttle trigger until the engine starts
and runs.
� Lay the trimmer on a flat, bare surface.
THROTTLE
TRIGGER
Fig. 11
� PRIME - Press the primer bulb 7 times.
� SET the start lever to the START position.
� PULL the rope until the engine starts.
� Allow the engine to run for 6-10 seconds.
RUN
� Squeeze trigger lock and throttle trigger.
NOTE: Squeezing the throttle trigger releases the start lever
to the RUN position.
TO START A WARM ENGINE:
PULL the rope until the engine starts.
TO STOP THE ENGINE:
Press and hold the switch in the stop “
engine stops.
” position until the
START
ENGINE
SWITCH
Fig. 12
TRIGGER
LOCK
THROTTLE
TRIGGER
Fig. 10
12