Download Alliance Laundry Systems UF250PV Operating instructions

Installation
After the anchor bolts are installed and the concrete
has cured, proceed as follows:
4 in.
(102 mm)
1. Place the washer-extractor adjacent to the
foundation. Do not attempt to move it by pushing
on the sides. Always insert a pry bar or other
device under the bottom of the frame of the
washer-extractor to move it.
71 in.
(1803 mm)
2. Remove the wood skid by unscrewing the
carriage bolts holding it to the bottom frame of
the washer-extractor.
3. Place the washer-extractor carefully over the
anchor bolts. Never attempt to lift the machine by
the door handle or by pushing on the cover
panels.
4. Raise and level the washer-extractor 1/2 inch off
the floor on three points, using spacers such as
nut fasteners.
5. Fill the spaces between the washer-extractor base
and floor with a good quality non-shrinking
machinery grout to ensure a stable installation.
Refer to Figure 11 for grouting the 135 pound
capacity model. Refer to Figure 12 for grouting
the 250 pound capacity model.
4 in.
(102 mm)
4 in.
(102 mm)
4 in.
(102 mm)
62 in.
(1575 mm)
250
CFS216N
Figure 12
6. Remove the spacers carefully, allowing the
washer-extractor to settle into the wet grout.
7. Position the mounting bolt washers and locknuts
on the anchor bolts and fingertighten locknuts to
washer-extractor base.
8. After the grout is completely dry, tighten the
locknuts by even increments – one after the
other – until all are tightened evenly and the
washer-extractor is fastened securely to the floor.
1
9. Remove the four red transport brackets used to
secure the washer-extractor during shipping.
Refer to Figure 13.
NOTE: Check and retighten the locknuts after five
to ten days of operation and every month
thereafter.
2
1
135
R077I
R007I
1
2
Bolt Holes
Frame Rails
Figure 11
F232102
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
23