Download Cisco AS5800 Installation guide

Cisco AS5800 Universal Access Server Overview
Figure 2
Cisco AS5800 Universal Access Server Fully Installed—Rear View
Power switches
(to boot system)
Router shelf
NETWORK PROCESSING ENGINE-150
Double
ground lug
Dial shelf
PEMs
POWER
POWER
MISWIRE
MISWIRE
Filter module
–48V
–48V
RTN
C
NC NO
–48V
–48V
RTN
C
NC NO
AC-input power shelf (optional)
H11450
Safety cover
not shown
The Cisco AS5800 universal access server is equipped with channelized T1 (CT1), E1 (CE1), or T3
(CT3) ingress interfaces that provide a synchronous telecommunication interface in both North
American and international environments. These ingress interfaces are installed in the Cisco 5814
dial shelf and contain all necessary functionality to terminate the telephone company connection.
The channelized trunk card is configured in the factory for either T1 or E1 framing, depending on
your order.
The Cisco AS5800 universal access server is also equipped with modem cards that recognize
Point-to-Point Protocol (PPP) and Serial Line Interface Protocol (SLIP) framing and convert pulse
code modulation (PCM) analog bitstreams to digital data. The modem card forwards converted and
packetized data to the dial shelf main processor, which examines the data and forwards it to the
router shelf. From the router shelf, the data is routed to an external network.
Cisco AS5800 Universal Access Server Regulatory Compliance and Safety Information
5