Download AddPac AP2520 VoIP User`s guide

PassFinder AP2520 VoIP Router/Gateway Operation Manual
3.1.
Installation
3.1.1.
Installation Procedure
z
Version 1.10 / Mar. 2002
Plug in the console cable and configure the console terminal. (Refer to
3.1.2 for details.)
z
Connect the network to the desired port. Use RJ-45 cable with the LAN 1
port for connection with ADSL/Cable Modem or Router, and the RJ-45
cable with the LAN 0 port for connection with the HUB/Switch. (For
gateway model)
z
Connect the network to the desired port. Use the V.35 cable with the
WAN(Serial) port for connection with DSU/CSU, and the RJ-45 cable with
the LAN port for connection with the HUB/Switch. (for router model)
z
Log in the Gateway after the booting message on the console with the
root account. (Configuration is only possible when logged in with the root
account.)
z
Switch to Configuration Mode.
z
For the WAN(Serial) port, configuration for mode (HDLC, PPP, Frame-Relay,
etc), as well as internet address assignment, is required. (Refer to Interface
Configuration.) (for router model)
z
Assign an internet address to the desired port of usage. (Refer to Interface
Configuration.)
z
Configure the settings for the routing and VoIP related. (Refer to Chapter 4
and 5.)
z
Confirm the configured settings. (Refer to the Gateway administrative
AddPac Technology Co., Ltd.
- 29 -