Download Vax VZL-6013A User guide

Vax VZL-401AA Magnum User Guide.qxd:VZL-401 User Guide
11/3/09
09:59
Page 8
www.vax.co.uk
Replace dirt container
Remove sole plate by lifting off (Fig.6/2).
Return dirt container to cleaner. Align slot on bottom of
dirt container with tab on cleaner. Push to snap into place
(Fig.5/14)..
Fig.5/14
Regular Maintenance
Each time the dirt container is emptied, the foam filter
should be checked and when necessary, cleaned (Filter
will be discoloured after use, this will not affect the
filter’s performance). Do not brush the filter. The cleaning
instructions may vary depending on the dirt conditions. In
some cases, more or less cleaning of the filter may be
required.
6. Belt or brushbar: removal
and replacement
Fig.6/2
Lift and remove brushbar. Dispose of old belt (Fig.6/3).
Fig.6/3
TOOL REQUIRED: Phillips screwdriver
To replace belt or brushbar
WARNING: to reduce the risk of injury from
! moving parts - unplug cleaner before changing
belt or brush.
Slide belt onto motor shaft (Fig.6/4).
To remove belt
Lay cleaner flat and flip cleaner to expose nozzle base
(Fig.6/1).
Fig.6/4
Place new belt in area of brushbar without bristles (Fig.6/5).
Fig.6/1
Base should lay flat and face up. To remove nozzle guard,
use Phillips screwdriver to remove the SIX (6 ) screws.
Arrows show location of screws (Fig.6/1).
Fig.6/5
8 belt or brush bar