Transcript
Instructions: Motorcycle Tank Bag 4. Connect the male end of the bottom strap into the female end of its quick-release buckle located on the bottom of the bag. 5. Using the buckles, adjust the length of each strap as needed for your motorcycle. Be sure that the straps do not cover your gauges or impair your ability to operate your motorcycle’s controls. Tuck any excess strap length under your bag into the strap pocket. If you choose not to use one or both of the security straps, store the straps in their pockets under the bag so they cannot flap loose while you are riding. STORM SHIELD DANGER For extra weather protection and visibility your Motorcycle Tank Bag comes with a high visibility pull-out storm shield, which is attached inside a zippered pocket at the bottom of your bag. To prevent mildew, dry the Storm Shield thoroughly before tucking it back into its zippered pocket. Be sure that your Tank Bag does not impair, restrict, or otherwise interfere with your ability to view the gauges or controls on your motorcycle. Storm shield stuff pocket CAUTION Be sure that your Tank Bag is securely attached to your motorcycle’s fuel tank, that all pockets are closed and all straps are secured before riding. TANK BAG Installation Your Motorcycle Tank Bag can be installed on both metallic and non-metallic fuel tanks. How you install your Motorcycle Tank Bag will vary according to your motorcycle and your personal preference. Expandable Cargo Compartment Your Motorcycle Tank Bag can expand for additional cargo by opening the zipper along the middle of the bag. Cleaning For motorcycles with metallic tanks, basic installation simply requires centering your Motorcycle Tank Bag on top of your motorcycle’s fuel tank and spreading out the magnetic corners on its base. For additional security you may wish to attach the bag with the provided top or bottom security straps (see below). Clean your Motorcycle Tank Bag with a soft brush and warm water and air dry. Do not machine wash or dry. DO NOT USE SOAP as it can damage the protective coatings on the fabric. The transparent map case on top of the bag should be wiped clean with a soft cloth to avoid scratching its surface. For non-metallic tanks and/or additional security, use the attached security straps (tucked under the non-slip base of your bag at the top and bottom) as follows: Your bag is factory warranted for workmanship and materials for two years after purchase. Warranty 1. Secure the top strap of your bag to the front of your motorcycle by wrapping the strap around your motorcycle’s head tube and passing the buckle end of the strap through the sewn-in loop on the other end. 2.Connect the male end of the top strap into the female end of its release buckle. 3. Secure the bottom strap by wrapping the strap under your motorcycle’s seat and through the frame, passing the buckle end through the sewn in loop. (See your motorcycle’s instruction manual for instructions on removing the seat.) ©2007 Designed in the U.S.A. 73717 07cM59_006