Download Scyan X7 User Manual - Fingerprint door lock Biometric door locks
Transcript
Scyan X7 Fingerprint Keypad Lock User Manual One touch to open Scyan Electronics Contents Active sensor area Fingerprint sensor Keypad 1. Features -----------------------------------------------------------4 2. Specifications ----------------------------------------------------5 3. How to scan your fingerprint ----------------------------------5 4. Programming Code ---------------------------------------------5 5. Fingerprint management---------------------------------------6 6. User Code Management-----------------------------------------7 7. Beep sound management ---------------------------------------8 8. Double verification mode ---------------------------------------8 9. Passage mode enabling/disabling ------------------------------8 10. Key unlock -------------------------------------------------------9 11. Low battery warning--------------------------------------------9 12. Additional power source ---------------------------------------9 13. System reset -----------------------------------------------------9 14. Troubleshooting ------------------------------------------------9 15. Lock installation -----------------------------------------------11 16. Product return -------------------------------------------------18 ·3· ·5· ·6· ·7· ·8· ·9· ·10· fig. 4 fig. 5 fig. 1 fig. 3 ·11· fig. 6 fig. 2 fig. 7 ·12· fig. 8 fig. 1 ·14· Continue rotating key clockwise while pushing lever until the lever is pushed in (see fig. 9b). Rotating key range is from 90° to 135°. Rotate the key fig. 2 fig. 3 counter clockwise, back to original position (see fig. 9c). Take the key out (see fig. 9d). fig. 6 fig. 4 fig. 5 fig. 7 fig. 8 fig. 9 fig. 10 fig. 12 fig. 13 Installation Option: The lock will stay on vertical position on the door as long as the two mounting screws were tied up in most case. You may put a tapping screw on inside chassis to increase lock stability. 1. Remove two screws in battery compartment. You will see mounting hole under battery compartment. 2. Use 1/8" (3 mm) Drill Bits to drill a hole on door. through mounting hole. 3. Screw tapping screw in. 4. Put battery compartment back. Product return: Please refer installation instruction to remove lock from door, remove levers from lock, and then refer the following diagram to pack lock. fig. 11