Download Users Manual
Transcript
Integrity Instruments PWR-ADPT-DAQ User Manual Integrity Instruments P.O. Box 451 Pine River Minnesota 56474 USA Order Phone Fax Phone Tech Phone 800-450-2001 218-587-3414 218-587-3120 http://www.integrityusa.com PWR AD-DAQ POWER ADAPTER FOR ALL M SERIES DATA ACQUISITION MODULES Page 1 Integrity Instruments PWR-ADPT-DAQ User Manual GENERAL The Integrity Instruments Power Adapter (PWR-ADPT-DAQ) is the solution for those who wish to run our M series modules from a higher source voltage. With the PWR-ADPT-DAQ module you can run any of our M series data acquisition modules from your own local power source up to 60 VDC. You need only to plug the power adapter into your data acquisition module via the convenient power plug, and your ready to accept your external power source to the screw terminals of the adapter. The chart shows the PWR-ADPTDAQ heat sink power dissipation for 40 and 60 MA draw. PWR-ADPT-DAQ HEATSINK 3.5 POWER IN WATTS 3 2.5 2 40 MA 1.5 60 MA 1 0.5 0 15 20 25 30 35 40 45 VOLTAGE IN VOLTS Page 2 50 55 60 Integrity Instruments PWR-ADPT-DAQ User Manual Electrical Characteristics: * V+ voltage up to 60Vdc at 60 ma output current * V+ input is diode protected with a 1N4004 * Power consumption is dependent on input voltage. * Plug center is positive, barrel is negative. Power Adapter Connection The plug of the power adapter is connected directly to the power receptacle of the Integrity Instruments data acquisition module. The external power is connected to the two position terminal strip, positive to the outside terminal, negative to the inside terminal. The unit has an adhesive backing strip, so the unit can be attached in the area. + Pos - Neg 1 R1 6.8K D2 2 1 1N4742 P1 1 2 3 Q1 TIP122 2 TB1 D1 1 1N4004 2 1 2 + - 2.5MM POWER PLUG CENTER POSITIVE Terminal Block 5.08mm Page 3 Integrity Instruments PWR-ADPT-DAQ User Manual NOTES: WARRANTY Integrity Instruments warranties all products against defective workmanship and components for the life of the unit. Integrity Instruments agrees to repair or replace, at it’s sole discretion, a defective product if returned to Integrity Instruments with proof of purchase. Products that have been mis-used, improperly applied, or subject to adverse operating conditions fall beyond the realm of defective workmanship and are not convered by this warranty. Copyright © 2000, Integrity Instruments All trademarks are property of their respective owners. PWR-ADPT PUB Page 4