Download Installation and User Manual
Transcript
WATERMAN STEAM SHOWER ENCLOSURE INSTALLATION AND USER MANUAL CONTENTS Steam Shower Enclosure Installation........................................2 Technical Information...................................................................2 Plumbing Requirements..............................................................2 Assembly.......................................................................................2 Tools and Materials.....................................................................2 Installation..................................................................................2 Safety Information......................................................................15 Steam Cabin Technical Specifications.....................................16 User Manual................................................................................16 LCD Display..............................................................................16 Control Panel............................................................................17 Steam Generator Cleaning........................................................21 Troubleshooting..........................................................................22 Waterman Steam Shower Enclosure Installation and User Manual 1 STEAM SHOWER ENCLOSURE INSTALLATION Before you begin, read the following installation and care instructions. Observe all local plumbing, building, and electrical codes. Unpack and inspect the product for any shipping damages. If you find damages, do not install. Contact Customer Service at 1.866.855.2284. If you need assistance or have questions while installing your shower enclosure, contact Customer Service. We recommend that all plumbing and electrical rough-in work be completed by a professional prior to shower enclosure assembly. Signature Hardware accepts no liability for any damage to the enclosure, walls, floor, or for personal injury during installation. TECHNICAL INFORMATION • • • 220 volt, 20 amp GFCI breaker Line 1, line 2 and ground (1 dedicated line for steam) The size of breakers and wire gages is determined by local, state, and national codes as interpreted by the installing electrician. PLUMBING REQUIREMENTS • • • • This unit is equipped with hot and cold braided water supplies with ½" NPT pipe threads. Install hot and cold shut off valves with ½" male NPT pipe threads to connect to water supplies. Tighten all connections prior to installation. We recommend preparing the drain location with the shower enclosure base on site. A drain pipe 2" in diameter is required, hose can stretch 6". Waterman Steam Shower Enclosure Installation and User Manual 2 ASSEMBLY TOOLS AND MATERIALS: Level Caulking Gun Set Square Screwdriver Adjustable Wrench Rubber Mallet Silicone Sealant Drill INSTALLATION 1. Set the shower tray in place. Place a level on the tray and adjust the tray legs as necessary until completely straight. Each leg should be touching the floor. 2. Attach the hand shower slide bar to the wall panel. Waterman Steam Shower Enclosure Installation and User Manual 3 3. Attach the top and bottom corner braces to the back middle glass panel. 4. Attach the back wall panel to the shower tray. Waterman Steam Shower Enclosure Installation and User Manual 4 5. Attach the shower seat backrests and shower basket (shampoo holder) to the left and right columns. M4 nut M4 gasket glassc olumn M4 black o-ring rightc olumn left column small copper meson M4*25 screw M8*25 hexagons crew blackg asket glassc olumn small decorative cap shampoo holder backrest supportb ar backrest decorative screw 6. Attach the side columns to the shower tray. Connect the flexible water feed tubes to the corresponding outlets. Waterman Steam Shower Enclosure Installation and User Manual 5 7. Install the door hinges. install on ther ight movable glass door installo nt he left fixedg lass door installo nt her ight fixedg lass door installo nt he left movableg lass door hinge (right) hinge (left) fixedg lass door hinge back cover (left) movable glass door hinge back cover (left) M6*10 screw M6*10 screw left fixed glassd oor transparent gasket transparent gasket transparent gasket transparent gasket left movableg lass door movable glass door hinge frontc over (left) fixedg lass door hinge frontc over (left) leftm ovable glassd oor left fixedg lass door 8. Attach the top and bottom corner braces and magnetic door stop to the doors. Waterman Steam Shower Enclosure Installation and User Manual 6 9. Attach the plastic sealing strips to the wall panels if not already attached. 309B seal 10. Attach the side panels to the shower tray. Waterman Steam Shower Enclosure Installation and User Manual 7 11. Remove the cover from the front column and attach the inner portion of the column to the shower tray. Connect the flexible water feed tubs and electrical wiring to the corresponding outlets on the shower tray. 12. Install the ceiling shower. Connect the exhaust fan and speaker. column M22n ut decorative cover ceilings hower 8.3(speaker ) 8.1(exhaust fan) Waterman Steam Shower Enclosure Installation and User Manual 8 13. Connect the flexible water feed tubs and electrical wiring to the corresponding outlets. S6 control box 8.1 8.2 8.3 exhaust fan! chromatherapy lamp! speaker ! display! 4 # hand shower front column cover ground connection $ jet " ceiling shower 3 steam generatord rain powers upply fixing ring HOT! COOL! water-in of cold waters upply touch panel! water-in of hotw ater supply powers upply water-ino fc oldw ater supply COOL! $ jet steam generator water-in of hot water supply(HOT) # hands hower ground connection steam generator drain 14. Attach the front column cover to the column and shower tray. Waterman Steam Shower Enclosure Installation and User Manual 9 15. Attach the door handle to the door. adjust screws on the door handle movable glassd oor gasket decorative cover nut inner door handle decorative cover gasket M5X20 machine screw outer door handle 16. Install the doors. Waterman Steam Shower Enclosure Installation and User Manual 10 17. Attach the magnetic cylinders to the glass shower enclosure cover. 18. Install the shower enclosure cover. Waterman Steam Shower Enclosure Installation and User Manual 11 19. Connect the glass panel and top cover. Attach the decorative trim pieces. 20. Attach the shower seats to the wall panels and shower tray. M4 black gasket seat decorative cap ST5X25 mushroom head tapping screw seat copper meson M8*25 hexagon screw Waterman Steam Shower Enclosure Installation and User Manual 12 22. Install the plastic seal strips according to the drawing specifications to prevent leakage. m 23. Adjust the magnetic seals, glass clips and door hinge as needed so that the door will close tightly. 24. Run a bead of silicone sealant around the base of the wall panels. Allow the silicone to dry 24 hours before use. Waterman Steam Shower Enclosure Installation and User Manual 13 25. Connect the water supply and electricity. Push the shower into place if necessary. Use a screwdriver and rubber mallet to push the seal strips inside the door frame flush against the wall. Waterman Steam Shower Enclosure Installation and User Manual 14 SAFETY INFORMATION • • • • • • • • When using this unit, basic safety precautions should always be followed. Children under the age of 16 should not be permitted to use the steam shower enclosure. Use this unit only for its intended purposes as described in this manual. Do not use any additional attachments not recommended by the manufacturer. Never drop or insert objects into openings in the steam shower enclosure. The unit must be connected to a supply circuit that is protected by a ground-fault circuit-interrupter (GFCI). The appropriate GFCI should be provided by the installer and should be tested on a routine basis. To test the GFCI, push the Test button. The GFCI should power off. Push the Reset button to restore the power. If the GFCI fails to operate in this matter, it is defective. If the GFCI fails to provide power to the shower enclosure and a ground current is flowing the user could potentially incur an electric shock. Do not use the shower enclosure and repairs performed by a qualified electrician before using. A green-colored terminal (or wire connector marked “G”, “GR”, or “Ground”) is provided within the front column. To reduce the risk of electric shock, connect this terminal or connector to the grounding terminal of your electric service or supply panel with a connector equivalent in size to the circuit of the conductors supplying this equipment. To reduce the risk of injury: • • • The wet surfaces of steam enclosures may be slippery. Use care when entering or leaving. The steam head is hot. Do not touch the steam head and avoid the steam near the steam head. Prolonged use of the steam system can raise internal body temperature and impair your body's ability to regulate temperature (hyperthermia). Limit steam use to 10 – 15 minutes at a time until you are certain of your body’s reaction. • Excessive temperatures have a high potential for causing fetal damage during the early months of pregnancy. Pregnant or possibly pregnant women should consult a physician regarding correct exposure. • Obese persons and persons with a history of heart disease, low or high blood pressure, circulatory problems, or diabetes should consult a physician before using the steam system. • If using medication, consult a physician before using the steam system as some medication may induce drowsiness or affect heart rate, blood pressure and circulation. Hyperthermia warning: Hyperthermia occurs when the internal temperature of the body reaches a level several degrees above the normal body temperature of 98.6° F. The symptoms of hyperthermia include dizziness, lethargy, drowsiness, and fainting. The effects of hyperthermia include: • Failure to perceive heat • Failure to recognize the need to exit the steam shower • Unawareness of impending risk • Fetal damage in pregnant women • Physical inability to exit the steam shower •Unconsciousness WARNING – The use of alcohol, drugs, or medication can greatly increase the risk of hyperthermia Waterman Steam Shower Enclosure Installation and User Manual 15 STEAM CABIN TECHNICAL SPECIFICATIONS Rated Power: 3.0 KW Rated Voltage: AC240V Rated Electric Current: 16A Frequency: 60 Hz Power Supply Location: Wall Water Supply: ½" NPT pipe thread, hot/cold water Water Supply Location: Wall Diameter of Drainage Pipe: 1-½" flex pipe Length of Drainage Pipe: 39" USER MANUAL LCD Display 1. Fahrenheit 2. Celsius 3. Temperature 4. Temperature Indicator 5. Timer Setting 6. FM Radio Function 7. FM Radio Volume 8. FM Radio Channel 9. Chromatherapy ON/OFF 10. Fan ON/OFF 11. Steam ON/OFF 12. Power ON Indicator 13. FM Radio Channel 14. MP3 ON/OFF Waterman Steam Shower Enclosure Installation and User Manual 16 CONTROL PANEL Steam Cabin Control Panel Power ON/OFF Steam Temperature Setting Steam Timer Setting Fan ON/OFF Chromatherapy Steam ON/OFF MP3 Radio Volume/Channel Radio Settings + Adjustment - Adjustment Steam Cabin Control Parts 1. Steam Temperature Sensor 2. LCD Display 3. Control Panel 4. Water Diverter 5. Water Volume Adjustment 6. Water Temperature Adjustment 7. Back Massage Jet 8. Steam Outlet 9. Hand Shower Set 10. Steam Generator Cleaning Liquid Jet Waterman Steam Shower Enclosure Installation and User Manual 17 CONTROL PANEL Power ON/OFF Push any button to light the display (Image 1). Push the Power button to turn the system on (Image 2) and off. When the power is turned off, the display and background light shuts off immediately while the drain valve for the steam generator remains running for one minute. Image 1 Steam Temperature Setting The default steam temperature setting is 113 degrees. To adjust the temperature, push the Steam Temperature Setting button (Image 3) until the desired temperature is reached. When the cabin temperature reaches 4 degrees above the set temperature, the steam generator automatically shuts off. When the cabin temperature reaches 4 degrees below the set temperature the steam generator automatically turns on. Image 2 Steam Timer Setting The default steam timer setting is 45 minutes. To adjust the timer setting, push the Steam Timer Setting button (Image 4) until the desired time is reached. The system automatically shuts off at the end of the specified time. Image 3 Image 4 Waterman Steam Shower Enclosure Installation and User Manual 18 CONTROL PANEL Chromatherapy The Chromatherapy button controls the color of the chromatherapy lights. The chromatherapy symbol on the LCD display flashes when the chromatherapy lights are turned on (Image 5). Press the Chromatherapy button to adjust the turn the lights on and off and to adjust the lights as desired. Image 5 Image 6 Fan ON/OFF The Fan button turns the ventilation fan on and off. When the fan is running, the fan symbol on the LCD display flashes. Hold the Fan button in for 3 seconds to switch the display from Celsius to Fahrenheit (Image 7-8). Image 7 Steam ON/OFF Push the Steam ON/OFF button to turn the steam function on (Image 9). When the steam function is on the steam ON/OFF symbol flashes. The steam function is automatically turned off when the cabin temperature reaches 4 degrees higher than the set temperature and on when the temperature drops to 4 degrees below the set temperature. Image 8 Image 9 Waterman Steam Shower Enclosure Installation and User Manual 19 CONTROL PANEL MP3 Press the MP3 button to select the MP3 function. Adjust the channel to match the channel set on the MP3 emitter. Hold the MP3 button in for 3 seconds to set the channel and volume. Image 10 FM Radio ON/OFF Push the FM Radio ON/OFF button to turn the radio function on. When the radio is on the FM Radio ON/OFF symbol flashes. The channel will default to that last selected. Image 11 Volume/Channel Push the Volume/Channel button with the radio on (Image 12) to adjust the volume. Push the buttons to make adjustments as necessary. To change the channel, press the button twice when the radio is on (Image 13). Push the buttons to scan. Image 12 Image 13 Waterman Steam Shower Enclosure Installation and User Manual 20 CONTROL PANEL Radio Settings Selecting and saving preset radio stations: • • • Turn the radio on. Push the Radio Settings button twice to display the preset numbers 1-8 (Image 14). Scan to the desired station and hold the Radio Settings button until the appropriate preset number is displayed. Image 14 Finding a preset station: • • Turn the radio on. Push the Radio Settings button to scan through the preset stations. STEAM GENERATOR CLEANING To clean the steam generator, remove the cover from the cleaning liquid inlet. Input 1L of mild detergent. Turn the steam function on to fill the generator with water. Before steam is released, turn the steam function off. Do not shut off the control system, the system will drain the dirty water automatically after 60 minutes. Repeat these steps to clean the steam generator every 3 months. Waterman Steam Shower Enclosure Installation and User Manual 21 TROUBLESHOOTING If the touch panel is not functioning properly: • Check the connection from the control panel to the power box. If the control panel and power box are properly connected and problems persist it may be necessary to replace the panel or box. If the steam function is ON but no steam is being released into the cabin: • Check to ensure the water supply valve has not been shut off. Turn the water supply valve on if necessary. • Remove the scale on the water level sensor and clean with warm water and a mild detergent. Replace the scale if it appears to be broken. • Make sure that the temperature setting is not lower than the room temperature. Reset the temperature if necessary. • Replace the thermal switch inside the heater. • If all parts appear to be clean and in working order and problems persist it may be necessary to replace the heater. If water does not stop being added to the steam generator: • Replace the water inlet valve. • Remove the scale on the water level sensor and clean with warm water and a mild detergent. If problems persist it may be necessary to replace the scale. If the unit will not turn ON: • Replace the heater or thermal switch. If water is leaking from the valve: • Replace the valve seal. If the water flow volume is low: • Impurities in the water supply can clog the filter resulting in low water flow. To remove clogs, remove the filter and rise with warm water. Waterman Steam Shower Enclosure Installation and User Manual 22