Transcript
J2 Panel Interface Pin Reference ID250 TTL to LVDS Adapter Card USER’S GUIDE ID250 Connectors J1: LVDS Connector Pin 1 2 3 4 5 6 7 8 9 10 Signal VDD VDD GND GND Y3+ Y3GND CLK+ CLKGND Pin 11 12 13 14 15 16 17 18 19 20 Signal Y2+ Y2GND Y1+ Y1GND Y0+ Y0GND GND J2: TTL Connector Pin Signal 12-bit 18-bit 24-bit 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 38 36 37 D0 D1 D2 D3 D4 D6 D27 D5 D7 D8 D9 D12 D13 D14 D10 D11 D15 D18 D19 D20 D21 D22 D16 D17 D24 D25 D26 D23 CLKOUT RED0 RED1 RED2 RED3 RSVD RSVD NA NA GREEN0 GREEN1 GREEN2 GREEN3 RSVD RSVD NA NA BLUE0 BLUE1 BLUE2 BLUE3 RSVD RSVD NA NA HSYNC VSYNC ENABLE NA CLOCK RED0 RED1 RED2 RED3 RED4 RED5 NA NA GREEN0 GREEN1 GREEN2 GREEN3 GREEN4 GREEN5 NA NA BLUE0 BLUE1 BLUE2 BLUE3 BLUE4 BLUE5 NA NA HSYNC VSYNC ENABLE NA CLOCK RED0 RED1 RED2 RED3 RED4 RED5 RED6 RED7 GREEN0 GREEN1 GREEN2 GREEN3 GREEN4 GREEN5 GREEN6 GREEN7 BLUE0 BLUE1 BLUE2 BLUE3 BLUE4 BLUE5 BLUE6 BLUE7 HSYNC VSYNC ENABLE RSVD CLOCK 35 Signal VDD GND VDD GND RED0 RED2 RED4 RED6 GREEN0 GREEN2 GREEN4 GREEN6 BLUE0 BLUE2 BLUE4 BLUE6 GND CLOCK ENABLE GND Pin 1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39 Pin 2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40 Signal VDD GND VDD GND RED1 RED3 RED5 RED7 GREEN1 GREEN3 GREEN5 GREEN7 BLUE1 BLUE3 BLUE5 BLUE7 GND VSYNC HSYNC GND J2 Panel Interface Pin Reference ID251 LVDS to TTL Adapter Card USER’S GUIDE ID251 Connectors J1: LVDS Connector Pin 1 2 3 4 5 6 7 8 9 10 Signal VDD VDD GND GND RX0RX0+ GND RX1RX1+ GND Pin 11 12 13 14 15 16 17 18 19 20 Signal RX2RX2+ GND RXCRXC+ GND RX3RX3+ GND GND J2: TTL Connector Signal VDD GND VDD GND RED0 RED2 RED4 RED6 GREEN0 GREEN2 GREEN4 GREEN6 BLUE0 BLUE2 BLUE4 BLUE6 GND CLOCK ENABLE GND Pin 1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39 Pin 2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40 Signal VDD GND VDD GND RED1 RED3 RED5 RED7 GREEN1 GREEN3 GREEN5 GREEN7 BLUE1 BLUE3 BLUE5 BLUE7 GND VSYNC HSYNC GND Pin Signal 12-bit 18-bit 24-bit 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 38 36 37 D0 D1 D2 D3 D4 D6 D27 D5 D7 D8 D9 D12 D13 D14 D10 D11 D15 D18 D19 D20 D21 D22 D16 D17 D24 D25 D26 D23 RED0 RED0 RED0 RED1 RED1 RED1 RED2 RED2 RED2 RED3 RED3 RED3 RSVD RED4 RED4 RSVD RED5 RED5 NA NA RED6 35 CLK UT NA NA RED7 GREEN0 GREEN0 GREEN0 GREEN1 GREEN1 GREEN1 GREEN2 GREEN2 GREEN2 GREEN3 GREEN3 GREEN3 RSVD GREEN4 GREEN4 RSVD GREEN5 GREEN5 NA NA GREEN6 NA NA GREEN7 BLUE0 BLUE0 BLUE0 BLUE1 BLUE1 BLUE2 BLUE2 BLUE1 BLUE2 BLUE3 BLUE3 BLUE3 RSVD BLUE4 BLUE4 RSVD BLUE5 BLUE5 NA NA BLUE6 NA NA BLUE7 HSYNC HSYNC HSYNC VSYNC VSYNC VSYNC ENABLE ENABLE ENABLE NA NA RSVD CLOCK CLOCK CLOCK Picture of ID251 LVDS to TTL Card Note: By default, the ID250 and ID251 cards supports 3.3V voltage. If the panel to be used supports 5V, please contact your distributor.
