Download USER GUIDE.cdr

MICROWAVE
SENSOR
Detection range under antenna longitudinal angle
USER GUIDE
The multifunctional sensor is suitable for all kinds of automatic door
Technical datas:
Technical: wave & CPU
Frequency: 10.525Ghz
Frequency density: <<5mW/cm
0°
Anti-interference: EMC
Detection principle: Doppler
2
comply with89/336EEC
Near to the door：
Power voltage: 12~24V AC or DC
adjust antenna angle to min . 0
Operation illustration with a too far distance
Power frequency: 50~60Hz
Installation height: Max 3m
Power consumption: < 2W
Radiation angle: level 120°,vertical 80°
output: standard relay
Detection range：4m(w) 3 m(D)
Max. power voltage AC220V, DC28V
Detection mode: motion
Max. Power current 1 A
Motion detection speed: Min. 5cln/5
Hold-output time
1S
(test along the longitudinal axis of antenna)
Size: 115x90x65(mm)
Adjust detection range: adjust planar
Weight(including wire): 220g
antenna elevation
Material: ABS plastic
Adjust detection sensitivity: adjust potentiometer
Color: silver gray
Near to the door ：
Environment temperature: -20℃~+55℃
Wire length: 2.5m
adjust antenna angle to 30°
0°
30°
Normal operation illustration
Structure:
Wire connect plate
45°
Elevation
Base plate
0°
adjuster
Far from the door ：
light
Antenna
adjust antenna angle to max . 45°
Normal operation illustration
Adjust detection range
Installation guide：
1. Caution: don't allow to press the antenna surface during installation.
Remark: The detection range has been tested before sale, the adjustment is required
2. Fix the sensor tightly for vibration prevention.
only under special situation.
3. Don't put the motion or vibration objects in the detection range.
Adjustment method:
Press the edge of the antenna by hands and rotate the fixed axis.
Open the sensor cover:
Open the cover from the base plate by using
a blade screwdriver.
Adjust sensitivity:
Wire connection
Remark: It need to adjust only when the sensor is not sensitive or the detection range is small.
Connect the wire goes through the hole to terminal.
Adjustment method:
Adjust the potentiometer by using mini-screwdriver, turn right to increase
detection range and sensitivity, otherwise decrease.
Connect power
Power supply
Signal
Min.
Sensitivity/
Detection range
Potentiometer
Max.
Sensitivity/
Detection range
Signal