Download New England Arbors VA68228 Installation Guide

A S S E M B LY I N S T R U C T I O N S
4’ x 4’ Raised Planter Bed
Please read through before starting assembly.
Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346, ext #20 (Mon. to Fri. 8:00 AM to 4:00 PM EST).
1. Post Caps (4)
2. Posts (4)
3. Side Panels (8)
4. 3.5” Stainless Steel Screws (16)
1
2
3
4
Not to Scale
General Information
• Read Instructions through carefully before beginning assembly.
• When assembling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
• We recommend an area approx 4’x 8’ for unobstructed assembling.
• You should not need to use excessive force when assembling components.
Ver 1.0/MAR 2013
1
4’ x 4’ Raised Planter Bed
STEP ONE
1
Raised Bed Installation
49½”
1
49½”
Excavate four, 8-inch holes in a square pattern (49½” x49½”)
as shown aside. Holes are to be 10 inches deep.
10”
2
8”
Place a post into each of the four holes. The posts will be buried
10 inches into the ground.
3
2
Stack the side panels two high between the posts.
While ensuring the posts and side panels are level, replace the
excavated dirt back and around the holes.
4
Using the screws provided, fasten the side panels to the posts.
(One screw for each intersection of side panel and post).
5
Pressure fit a post cap onto each of the posts.
3
4
5
2
3605 32nd st., Building 3, Port Huron MI USA 48060
Toll Free Phone: 1 800 282 9346 Toll Free Fax: 1 877 464 9286
www.newenglandarbors.com