Download New England Arbors VA68228 Installation Guide
Transcript
A S S E M B LY I N S T R U C T I O N S 4’ x 4’ Raised Planter Bed Please read through before starting assembly. Check Box for These Contents In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346, ext #20 (Mon. to Fri. 8:00 AM to 4:00 PM EST). 1. Post Caps (4) 2. Posts (4) 3. Side Panels (8) 4. 3.5” Stainless Steel Screws (16) 1 2 3 4 Not to Scale General Information • Read Instructions through carefully before beginning assembly. • When assembling components, place on a non-abrasive surface (i.e. shipping box) to avoid scratching. • We recommend an area approx 4’x 8’ for unobstructed assembling. • You should not need to use excessive force when assembling components. Ver 1.0/MAR 2013 1 4’ x 4’ Raised Planter Bed STEP ONE 1 Raised Bed Installation 49½” 1 49½” Excavate four, 8-inch holes in a square pattern (49½” x49½”) as shown aside. Holes are to be 10 inches deep. 10” 2 8” Place a post into each of the four holes. The posts will be buried 10 inches into the ground. 3 2 Stack the side panels two high between the posts. While ensuring the posts and side panels are level, replace the excavated dirt back and around the holes. 4 Using the screws provided, fasten the side panels to the posts. (One screw for each intersection of side panel and post). 5 Pressure fit a post cap onto each of the posts. 3 4 5 2 3605 32nd st., Building 3, Port Huron MI USA 48060 Toll Free Phone: 1 800 282 9346 Toll Free Fax: 1 877 464 9286 www.newenglandarbors.com