Transcript
Shutter Hardware Installation Instructions -For new or existing shutters, Louver, Panel, or Board and Batten Kit Contains: (4) Hinges (2) "S" Hooks (10) Screws "S" Hook Hinge Hinge Installation Step 1 Determine where the hinges will be installed. Typically the hinges are installed near the ends of the shutters. See Figure at right. Note: If placing hinges over Shutter Loks, be sure the pilot holes don't interfere with the Shutter Loks. Step 2 Using the marks on the front of the hinges as guides, use an 1/8" drill bit and drill pilot holes through the hinge and shutter. Step 3 Securely attach the hinges to the shutter with the enclosed screws. "S" Hook Installation Step 1 Place the "S" Hook in the desired location. Normally the hooks are installed at the bottom corner of the shutter. See Figure 1 at right. Step 2 On the back of the "S" Hook is a fin. This is where the screw will be placed. After the position of the "S" Hook is determined, use an 1/8" drill bit to drill through the fin and into the bottom of the shutter. Step 3 Securely attach the "S" Hook to the shutter using the screws provided.
