Download Q-Logic SB-RACKKIT User's Manual
Transcript
SANbox 5000 Series Fibre Channel Switch Rack Mounting Guide Rail Kit SB-RACKKIT 2 1 3 3 3 5800V/5802V 4 5202/5602 5200/5600 L 0 A L 1 A L 2 A L 3 A L 4 A L 5 A L 6 A L 7 A L A L A L A L A L A L A L L A L A 16 A L 17 A L 18 A L 19 A 1. Rack rail (2) 2. Switch rail (2) 3. Screw, w/washer 10-32 x 3/8 in. (14) 4. Washer, centering a (8) a For use only on racks with square holes. Tools Required Crosshead screw driver, medium WARNING!! Heavier products should be placed near the bottom of a rack or cabinet. A top-heavy rack can become unstable resulting in equipment damage or personal injury. 59109-03 A *59109-03 A* D SANbox 5000 Series Fibre Channel Switch Rack Mounting Guide Install Switch Rails Install the switch rails on the switch using two screws to secure each rail. The switch can be mounted flush or with a 1.25 inch setback depending on how you match the holes. 2 1 3 1 2 1. Switch rails, flush mount 3. Screws, 10-32 x 3/8 2. Switch rails, with setback Install Rack Rails Extend the rack rails to fit the inner dimensions of the rack. The rail flanges on both ends fit inside the rack. Be sure that the inner rail is toward the front. 3 2 NOTE: If the rack holes are square, use a centering washer with each screw. 1 Fasten the rail flanges to the rack at both ends with two screws using the upper and lower holes. 1. Screws 2. Inner rack rail 3. Centering washer Install the Switch 1. Slide the switch and rail assembly into the rack rails. 2. Fasten the switch to the rack with two screws: one through each switch rail flange. 1 1 1. Screws D Corporate Headquarters QLogic Corporation 26650 Aliso Viejo Parkway Aliso Viejo, CA 92656 949.389.6000 Europe Headquarters QLogic (UK) LTD. Quatro House Lyon Way, Frimley Camberley Surrey, GU16 7ER UK www.qlogic.com +44 (0) 1276 804 670 © 2008 QLogic Corporation. Specifications are subject to change without notice. All rights reserved worldwide. QLogic and the QLogic logo are registered trademarks of QLogic Corporation. All other brand and product names are trademarks or registered trademarks of their respective owners. Information supplied by QLogic Corporation is believed to be accurate and reliable. QLogic Corporation assumes no responsibility for any errors in this brochure. QLogic Corporation reserves the right, without notice, to make changes in product design or specifications.