Download Dell OptiPlex XE (Early 2010) How to Use
Transcript
About Warnings WARNING: A WARNING indicates a potential for property damage, personal injury, or death. Mounting Your Dell™ OptiPlex™ XE Using a Wall-Mount Unit WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. NOTE: The size of the wall-mount unit differs based on the computer’s form factor. 1 If you are mounting a computer with the optional Ingress Protection 51 (IP51) kit attached, remove the paddings from the wall-mount unit. February 2010 2 Mount the wall-mount unit to the wall using the screws that shipped with the unit. 3 Place the computer into the wall-mount unit. Without the IP51 kit With the IP51 kit 4 Replace the two screws on the wall-mount unit. Without the IP51 kit With the IP51 kit ____________________ Information in this document is subject to change without notice. © 2010 Dell Inc. All rights reserved. Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden. Trademarks used in this text: Dell, the DELL logo, and OptiPlex are trademarks of Dell Inc. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.