Download Avaya Bogen Paging Control System Expansion Assembly Model PCMAAD User's Manual
Transcript
PEC CODE: 5323-107 COM CODE: 408186021 MODEL: LUPCMADD Paging Control System Expansion Assembly Model PCMADD Package Contents Your carton contains: * LUPCMADD Paging Control System Assembly * Pair of Rack Brackets * Power Supply * Installation Manual * Male-to-Male RCA Cable * Male-to-Female “Y” Adapter * Mounting Screws Description The LUPCMADD Paging Control System Expansion Assembly can only be used with a LUPCMALL Paging Control System or another LUPCMADD to add more paging zones to your paging system.The LUPCMADD will add three additional paging zones to your system when the LUPCMALL or LUPCMADD already includes three zone paging modules. Before You Start... Verify that there is a standard electrical outlet available for the power supply (not controlled by a wall switch). Verify that there is at least 12” of open wall or rack space below the existing LUPCMALL or LUPCMADD. Installation STEP 1 - If there are Zone Paging Modules to add to the PCMADD, please do so before you mount it. STEP 2 - Mount the LUPCMADD approximately 4” below the existing LUPCMALL or any additional LUPCMADDs. STEP 3 - Disconnect power from the entire PCM system. STEP 4 - Follow the wiring diagram (see Figure 2) to connect the CPU modules together. STEP 5 - Use the chart on the right (Figure 1) to set the CPU module switches. STEP 6 - Verify connections and settings, then power up the system. NOTE: Refer to the LUPCMALL manual for speaker connections and operation of system. Figure 1: CPU Module Switches LUPCMADD Switch Set to On Module 1 2 3 4 5 6 7 8 9 10 1 2 2, 3 3, 3, 3, 4 4, 4, 1 1 2 2, 1 1 2 Physical Zones 10-18 19-27 28-36 37-45 46-54 55-63 64-72 73-81 82-90 91-99 * All of the switches are off left. Page 1 of 2 Issue 1, October 1999 Specifications subject to change without notice. © 1999 Bogen Communications Inc. All rights reserved. Part No. 54-2010-01 Printed in Korea 9910 Select Code: 701-000-110 Figure 2: Wire Connections PC M TIM PC M CP U PC M TB M PC M ZP M PC M ZP M PC M ZP M RCA JACK X1 X2 IN RT LPB X3 GM X4 IN RT HPB GM EM/S C GN D AU X GN D + 12 VDC - 1.5 A PC M CP U PC M ZP M Wiring Connections X1 FROM PCMALL X1 X2 X3 X4 TO PCMADD X1 X2 X3 X4 X2 IN RT LPB X3 GM X4 IN RT HPB GM EM/S C GN D AU X GN D + 12 VDC - 1.5 A USE PROVIDED “Y” ADAPTER FOR MULTIPLE LUPCMADDs IMPORTANT -If using Hi-Power background music, also connect HPBGM (IN & RT) terminals of the units together. -If using Lo-Power background music, also connect LPBGM (IN & RT) terminals of the units together. Page 2 of 2