Transcript
S P E F C I L E ET-PKD110S Ceiling mount bracket for low ceilings D escription This ceiling mount bracket is used when mounting a PT-DZ570 series DLP ™ projector to low ceilings. Specifications Vertical correction angle: Horizontal slant correction angle: Horizontal turn correction angle: Dimensions (W × H × D): +5°, -15° ±10° ±3° 219 × 83 × 282 mm (8-5/8˝ × 3-9/32˝ × 11-3/32˝) Approx. 1.5 kg* (3.3 lbs*) Weight: * Average value. May differ depending on models. Parts Attachment plate . . . . . . . . . . . . . . . . . . . . . . . . 1 Projector mount bracket . . . . . . . . . . . . . . . . . . . 1 Angle adjuster . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Washer-fitted bolts (M6 × 12) . . . . . . . . . . . . . . . 8 Washer-fitted bolts (M4 × 12) . . . . . . . . . . . . . . . 4 Caution: • Mounting should be done by a qualified technician. • Make sure that the mounting (ceiling) area has sufficient strength. • Read the enclosed mounting instructions thoroughly before starting. • Do not use an electric screwdriver or impact driver to tighten screws. Use a torque driver or hexagon torque wrench and tighten screws to the torque specified in the instructions. • When the product is no longer going to be used, have it disposed of quickly by a professional disposal service. Dimensions 208.5 (8-7/32) 130 (5-1/8) 37 (1-15/32) Attachment plate Attachment plate 160 (6-5/16) 173.5 (6-27/32) Illustration shows the bracket attached to a projector. 8.5 (11/32) 2-3-R5 (2-3-R3/16) 276 (10-7/8) Projector 95 (3-3/4) 125 (4-29/32) 65 (2-9/16) 65 (2-9/16) 145 (5-23/32) Attachment plate 70 (2-3/4) 20 (25/32) 35 (1-3/8) unit : mm (inch) NOTE: This illustration is not drawn to scale. DLP and the DLP logo are trademarks of Texas Instruments. Weights and dimensions shown are approximate. Specifications subject to change without notice. As of October 2010 SFD10A016 1/1