Transcript
SO 1447C PDD51-VB
5-Dec2011
63mm
SPECIFICATIONS
Clock 12/24 format with hour/ minute
99mm Step measurement range 0 - 99,999 steps
Distance measurement range 0 — 99.99 km or mile
Exercise timer range 23 hrs 59 mins
Stopwatch measurement capacity | 9 hrs 59 mins 59.99 sec
Calorie measurement range 0 — 99,999 Kcal
Fat measurement range 0 —12,986 g
Target distance range 0 — 99.99 km or mile
Target timer range 23 hrs 59 mins
Target speed range 0 — 39.9 km/h or mile/hr
Body weight range 30kg — 219kg or 661bs — 4791lbs
Body height range 100cm — 249cm or 40” — 99”
Odoemter 9999km or mile
Power 1x CR2032 3V battery
PPD7zA
AS MOD RTE Cex
VA VA VE NEXT По com
Art No.:PYLE_SPORTS-PPD71
FEATURES BATTERY INSTALLATION HOW TO USE THE CLIP INITIAL SETTING Note : It is strongly recommended that the user calibrate the The unit enter into Calibrate RUN mode, Press SET to confirm
* Daily Step Remove the battery cover at the back of the case by After replacing battery, the unit enter First Use Setting Mode. Ls “unit will use onyy statistical data based on the height and advance lo SET 9100 meter. Price SET to confirm the "
. . ; sliding the direction shown below. Insert a new CR2032 1. Attach the clip to the Set Unit . E. + : ’ y o.
* Daily Exercise Timer , es input by the user. The performance of the unit will not be in its Distance. Now the unit is ready for Calibrate Running Stripe
battery into the battery compartment with the positive pole Dt. 1) Press SEL to toggle between KM or !
* Daily Distance facing up. Slide the battery door back on pedometer. For correct - | > Mile, Press SET to confirm to advance full capacity. Length. Press SET and start running. At the time distance
alignment, see the clip on Loli to Set Clock covered, press SET to stop. Press SET again to confirm the
° Daily Calorie th d ? t d || vt If KM is selected, the scale of the unit Pedometer Calibration calibration for running and enter calibration for walking.
y ji i i .
* Daily Fat Burn © pedometer and sma MT wil be ы XM, KG, Meter oe of the unit You can choose Yes and No between with the SEL button. Repeat above process for Walking.
С t Speed arrows. will be in Mile. LB. Inch Choose YES and confirm with the SET button. - - =
urrent Spee co ow co ow * The unit enters into Calibrate RUN/WALK mode, Press в H р : H ;
Average Speed I I Dil I À DIU) SET to confirm and advance to SET RUN/WALK Distance. lla «—> |=’ = €
* Maximum Speed 2. Attach the pedometer to nl IL 1 ni) * Press SEL to set the run distance, increment by 100 meter, WAL K uN
. ini ; ; - , - Press SET to confirm the Distance. Now the unit is ready v SET
Target Training (Step / Time / Distance / Speed) your belt or waistband. If cy hr enn for Calibrate Running Stripe Length. Press SET and start Set calibretíon distance b
» 7 Days Memory you attach it as shown, you 5 running. sema SEL to advance to | MET
’ SET Clock pressing SEL to advance to | ¡y 4 y
* Week Total Memory can read the values from Press SEL to toggle 12 or 24 hr format, Press SET to confirm and | * At the time distance covered, press SET to stop. Display desirable distance increment | <<
« Odometer © advance to set HR, DONE and SAVED appears; the calibration was correct by 100m max to 1000m n nm
above when wearing it. Or Press SEL to advance to desirable HR, Press SET to confirm and | and was saved.
* Clock advance to set MIN Vv SET
you can put the pedometer Press SEL to advance to desirable MIN, Press SET to confirm ; ;
* Stopwatch without a clip in your and advance to set Weight Note: It is important that you also perform the calibration for ОПСС
* Km / Mile unit KEY ASSIGNMENT pocket. WET CT walking, ibed i wing section: CITE
. | 1 ! * Press SET again to confirm the calibration for running and TADT
12/24 hour format | SEL ML 4 x L 4 enter calibration for walking. Repeat above process for 5 AR
* Pedometer calibration ACCESSORIES cn q Walking. Y SET
y [IA step
» Odometer save Ju MI (OC M 11
CJ
SET Weight and Height Calibration not Successful
The unit default the weight of user to be 50KG or 110LB In case the calibration was not successful, the display FAIL v pun
MODE Press SEL to advance to desirable weight, Press SET to confirm appears. After a few seconds the display CALI FOR
and advance to set Height RUNNING or WALKING appears again and you can start a Y SET
The unit default the height of the user to be 150cm or 59inch new calibration. что ато о = =
Press SEL to advance to desirable Height, Press SET to confirm e |] E FH ; р
and advance to Calibration Mode Note: After Calibration, if the height is changed, all = “ue “pun
: ; Note: It is necessary to enter the correct weight to receive calibrated data will be lost. And the stride length will be reset NE J TL |
Wearing clip Battery CR2032 a meaningful value of calorie consumption and fat burning. according to the new entry of height.
After the initial setting, you are ready to go.
-1- -3- -4- -5- - 6 -
TURN ON/OFF Pedometer Function Main Mode Target Zone Target Alert Stopwatch Mode Memory Mode
PROS EE ey un fil the 2 foot print icon appear to tum on By pressing the SEL Button in the main mode, you can see User can select one of the following targets for his own daily For Step, Timer and Distance, there will be an alert when target | In Exercise Mode, user can change to Stopwatch model By This unit will record the daily data (step, distance, fat burnt,
Tot ff PRESS SET k current information of STEP in upper display, and sub workout target Distance, Speed, Step and Timer. meet. For Speed, there will be an alert when below target. press SEL key calorie, timer) for the past seven day, 7 days accumulated data
o turn off, ey. information in lower display as below: ne unit defaults as Target Step. If user desire other workout | , (total Step, total distance, total calorie, total fat burnt),
« CLOCK ata, please HOLD SET key In Exercise Mode until SET The unit defaults the following workout data: second
. appear on the upper row as In figure. Target Step: 10000 steps A - >, MEMORY MODE displ rtA
STEP STEP EXERCISE TIMER isplay sequence(part A)
Ct Can * DISTANCE and * Press SEL to toggle between four target types, Press SET to confim Target ee Mile | A |] | Press SET ; A 0 : | ) Hold SET
* CURRENT SPEED . : | TT Tre | Stan /stop | > rese srer = ser =
À Ц Li a Li Press SEL to advance to desire target values, Press SET to confirm Target Speed: 0 Km/hr or Mile/hr. и пл — nt 32 SEL | |
|123 V (6 Clock STEP Once selected, the pedometer mode will display the selected y vu uy € - | == —_— — =
{ (© J | PRESS SET ied a E AC Howser A AA information Stopwatch 1/100 sec EMANAN | 3---3-- 1 AANAN
D LI IC es. MG IC a PULL | Coin” Joe” | fous UV
LL — | Teruet CET Activate/Deactivate Target Alert Daily Record Mode ys before data Te узы
Note: Ped t ‘tbe t d ON/OFF when it is in 1 PM ; ; ; ;
Stopwatch mode and 2) Memory mode Cuma a | a SEL i ! od SEL key to Activate/Deactivate target Alert in Exercise Calorie, Fat Burnt, Average Speed and Maximum Speed 0:00 mensa STEP WEEK TOTAL nm
` Ld ode automatically record daily. These data reset every night at 0: SEL |) 100 SEL DI
SEL SEL Fr q r r Y Calorie / Fat burned Step / Daily average speed step / Daily max Speed === nan — a
Operation Modes JE 1 1 rt MEL 019 “= uuu UU
: Current Speed Distance Tar ot Tar ot ) 1 ( Hold SEL ) { =~ Odometer Week Total data
: The unit has 4 operation modes : Main, Exercise, Record, STEP o STEP = = р, mann p STEP Target | ===) | Target CL SEL
; Memory LAD se LL LI US ' P ALER! P ALERT
: ML <— MDI MEMORY MODE display sequence(part B)
Main Exercise aa a a a a === q y y
STEP STEP SPD km/h km LL ! L L ! e Record $
i" | r a 0 pa 14? nr 3 fl, ! AL! Alert symbol ¥ is displayed = alert on TER m m SM mr
Jd Ld 4 vi Target Target _ Alert symbol not displayed = alert off Scroll Through the records by pressing the SEL key. ) TH TH
LI moDE Lu : 040 Tm Yi 2, 3, AUS LAA,
Target tt | 3 | ЕЕ | =) рр | o:á:á38eo0 0 _'oo08000000 MMMM IN Memos | a
: N nana Fr - SET re SEL Note: Features Reset - including Daily Step, Training Timer, hes HULL Jeer oon non
Ju Note: Distance and Timer reset automatically every night at 0:00 a I Distance, Calorie, Fat Burnt, Average speed, Maximum
o. ln mus speed. In Exercise and Record Mode, hold SET button to — == —
LS Memo MODE Record Te 063 1 1 167 reset all daily data to 0. m Y A
; ры! SET SET SET
STEP кс! Exercise Mode Liss wis Ly sg
Mm i li li « nnnnn 1 nAN Mn
Dí MODE LI By pressing the SEL button in the Exercise mode, you can a 1 a (ays LILILILILS Days MAL (Days Lig
к €— «nm choose between the sub functions Target SPD km/h Target a Daily Step/Daily Timer Daily Step/Daily Distance ally Calorie/Daily Fat bum
« MUTUA Ñ * Target Zone q 1! т SET(Loop)
ays LALILILILS Lig * Stop watch 5 {i 9 PEE:
: Set Target Select Target Type
: Scroll Through the operation mode by pressing the MODE key.
| -7- -8- -9- - 10 - -11 - -12-
od Save f CAUTION |
ometer Save function ; 1 ; :
Before changing battery or perform total reset. Please write This unit is not water resistant. Do not get the pedometer wet
down the accumulated distance travels and use this function to | There are 4 resetting procedures for user to reset the data.
input distance back to the pedometer. ;
To set, go to odometer mode, HOLD SET until ODOMETER 1. Total Reset — INITIAL SETTING
SAVE screen appear and first digit in the lower low start to Change battery or Hold SET and SEL buttons, repeat INITIAL :
blink, press SEL to choose desire number and SET to confirm. SETTING procedure.
Repeat the procedure until desirable distance is entered. 2.Reset Clock without resetting workout data
In Clock mode, Hold SET button to enter setting mode.
- E, Repeat process in the SETTING SECTION described above.
it DI. “4 3.Reset Weight/Height/Calibration
MBILA DIT MI In clock function, Hold SET button to enter Calibration mode.
mm | + = = — Repeat process in the PEDOMETER CALIBRATION
M CE T described above.
Ll JL 4 Features Reset - including Daily Step, Training Timer,
Distance, Calorie, Fat Burnt, Average speed, Maximum
nn М speed. In Exercise and Record Mode, hold SET button to
) ( 10) ( | ( 10) ( reset all daily data to 0.
a <a @" a” a a
uz km km
ARANA ag
МЫ a
TROUBLESHOOTING
Note: Why is the displayed covered distance incorrect?
1.0DO can only be reset to zero during TOTAL RESET or Have you performed a calibration? For optimum results the
battery changing calibration has to be performed for "walking" as well as
2.To avoid ODO info lost during battery changing, user can running". A shuffling gait, bad shoes and varying surface
re-enter the value in “Set Odometer ” session above can lead to inaccurate measurements. A lower distance is
measured when climbing steps, because the watch is
designed for even surfaces. Choose the used during
calibration speed when walking or running. Please note that
the measurements of untrained persons can be inaccurate/
irregular.
- 13 - - 14 -
