Download Argos MDT-10DMN3 Instruction manual
Transcript
10 L Dehumidifier Instruction Manual 1 2 CONTROL PANEL 3 2 ON/OFF Switch 1 1.ON/OFF Switch & Power On indicator light Press the ON/OFF button once to start the operation of the unit. The power on indicator light [3] will be illuminated. Press the button again to switch the unit off. 2. Water tank full indicator light When the water tank is full, the unit will switch itself off and this water tank full indicator light will be illuminated. NOTE : When the frost builds up on the evaporator coils, the automatic defrost function will be started. The compressor will be turned itself off and the fan will continue to run until the frost is removed. - The unit will continue to operate until the water tank is full or you switch it off. - Ensure to switch it off when not in use. 3 PARTS Front Rear Control panel Air intake grille Handle Air Outlet grille Continuous drainage port Water tank Water level window Power cord hook (Used only when storing the unit.) Air filter (behind the air intake grille) Power Plug Power Cord Placement A dehumidifier operating in a basement will have little or no effect in drying an adjacent enclosed storage area, such as a closet, unless there is adequate circulation of air in and out of the area. 40cm or more Do not use outdoors. This dehumidifer is intended of indoor residential applications only. This dehumidifier should not be used for commercial or industrial applications. Place the dehumidifier on a smooth, level floor strong enough to support the unit with a full bucket of water. Allow at least 20cm of air space on all sides of the unit for good air circulation. Place the unit in an area where the temperature will not falll delow 5OC(41OF). The coils can become covered with frost at temperatures below 5OC(41OF), which may reduce performance. Place the unit away from the clothes dryer, heater or radiator. Use the unit to prevent moisture damage anywhere books or valuables are stored. Use the dehumidifier in a basement to help prevent moisture damage. The dehumidifier must be operated in an enclosed area to be most effective. Close all doors, windows and other outside openings to the room. 4 Air outlet grille Air inlet grille 20cm or more 20cm or more 20cm or more 20cm or more OPERATION When using the unit When first using the dehumidifier, operate the unit continuously 24 hours. This unit is designed to operate with a working environment between 5OC and 35OC. If the unit has been switched off and needs to be switched on again quickly, allow approximately three minutes for the correct operation to resume. Do not connect the dehumidifier to a multiple socket outlet, which is also being used for other electrical appliances. Select a suitable location, making sure you have easy access to an electrical outlet. Plug the unit into a 220~240V 50Hz(Refer to the nameplate located on the side/rear of the unit ) electrical socket-outlet with earth connection. Make sure the water tank is correctly fitted otherwise the unit will not operate properly. EMPTYING THE WATER TANK 1. Pull out the water tank a little. When the water tank is full, the unit will automatically stop running, and the Full indicator light will illuminate. Slowly pull out the water tank. Grip the left and right handles securely, and carefully pull out straight so water does not spill. Do not put the water tank on the floor because the bottom of the water tank is uneven. Otherwise the water tank will fall and cause the water to spill. Discard the water and replace the water tank. The water tank must be in place and securely seated for the dehumidifier to operate. When the water tank is put back in its correct position, the indicator light will go off and the unit will re-start. NOTES: When you remove the water tank, do not touch any parts inside of the unit. It may damage the product. Be sure to push the water tank gently all the way into the unit. Put the water tank back to the unit by force may damage the unit or water tank. - Do not remove the float from the water tank, the water tank full sensor will no longer be able to detect the water level correctly without the float and water may leak from the water tank. 5 2. Hold both sides of the water tank with even strength, and pull it out from the unit. 3. Pour the water out. CONTINUOUS DRAINAGE Please follow the steps to setup the continuous drainage. 1. Switch off the unit and remove the plug from the mains. 2. Remove the rubber plug from the back of the unit. 3. Insert the drain tube (12mm outer diameter - not included) to the continuous drainage port. 4. Place the other end in a drain. Make sure the tube is free from twists and bends. Remove the rubber plug Insert the hose from the drain outlet Note: - The water tanke has to remain in place during the continuous drainage. - If the continuous drainage is no longer to use, remove the drain tube and put the rubber plug back the drainage port. CARE AND MAINTENANCE Turn the dehumidifier off and r emove the plug from the wall outlet before cleaning. Household Drain Cleaner 1. Clean the Grille and Case Use water and a mild detergent. Do not use bleach or abrasives. Do not splash water directly onto the main unit. Doing so may cause an electrical shock, cause the insulation to deteriorate, or cause the unit to rust. The air intake and outlet grilles get soiled easily, so use a vacuum attachment or brush to clean. 2. Clean the water tank Every few weeks, clean the water tank to prevent growth of mold, mildew and bacteria. Partially fill the water tank with clean water and add a little mild detergent. Swish it around in the water tank, empty and rinse. NOTE: Do not use a dishwasher to clean the water tank. After clean, the water tank must be in place and securely seated for the dehumidifier to operate. 6 Thinner No 3. Clean the air filter The air filter behind the front grille should be checked and cleaned at least every 30 days or more often if necessary. NOTE: DO NOT RINSE OR PUT THE FILTER IN AN AUTOMATIC DISHWASHER. To remove: Pull the water tank out as shown in Fig.A. Grasp the lower side of the filter and pull it downward, see Fig.B. Clean the filter with warm, soapy water. Rinse and let the filter dry before replacing it. Do not clean the filter in a dishwasher. Fig. A To attach: Insert the air filter into the unit from the side and push it upward. See Fig.C CAUTION: DO NOT operate the dehumidifier without a filter because dirt and lint will clog it and reduce performance. Fig. B Fig. C Power cord 4. When not using the unit for long period Band After turning off the unit, wait one day before emptying the tank. Clean the main unit, water tank and air filter. Tie up the cord with the band. Cover the unit with a plastic bag. Store the unit upright in a dry, well-ventilated place. 7 TROUBLESHOOTING TIPS Before calling for service, please check the points below : Problem Unit does not start What to check , Make sure the dehumidifier s plug is pushed completely into the outlet. Check the house fuse/circuit breaker box. Dehumidifier has reached its preset level or bucket is full. Water tank is not in the proper position. Dehumidifier does not dry the air as it should Did not allow enough time to remove the moisture. Make sure there are no curtains, blinds or furniture blocking the front or back of the dehumidifier. Check that all doors, windows and other openings are securely closed. Room temperature is too low, below 5 C(41 F). There is a kerosene heater or something giving off water vapor in the room. The unit makes a loud noise when operating The air filter is clogged. The unit is tilted instead of upright as it should be. The floor surface is not level. Frost appears on the coils This is normal. The unit has Auto defrost feature. Water on floor Hose to connector or hose connection may be loose. Intend to use the water tank to collect water, but the back drain plug is removed. 8 TECHNICAL DATA Model Power Supply Power consumption Dehumidifying capacity (at 30oC, 80%RH) Water Tank Refrigerant Recommend room size Working temperature Dimension W X D X H Weight MDT-10DMN3 220-240VAC 50Hz 250 10 W L/24h L 1.5 R134A Up to 18 5 to 35 330 X 260 X 420 13 m2 o C Mm Kg 9 10 PRODUCT GUARANTEE This product is guaranteed against manufacturing defects for a period of Year This product is guaranteed for twelve months from the date of original purchase. Any defect that arises due to faulty materials or workmanship will either be replaced, refunded or repaired free of charge where possible during this period by the dealer from whom you purchased the unit. The guarantee is subject to the following provisions: - The guarantee does not cover accidental damage, misuse, cabinet parts, knobs or consumable items. - The product must be correctly installed and operated in accordance with the instructions contained in this manual. - It must be used solely for domestic purpose. - The guarantee will be rendered invalided if the product is re-sold or has been damaged by inexpert repair. Specifications are subject to change without notice. - The manufacturer disclaims any liability for the incidental or consequential damages. - The guarantee is in addition to, and does not diminish your statutory or legal rights. Guarantor: Argos Ltd 489 - 499 Avebury Boulevard Central Milton Keynes MK9 2NW