Download User manual

Short code
Full-text message
PSER
PAN SENSOR ERROR
PTCM
PAN/TILT SENSOR CAL MISSING
The pan/tilt sensors are not calibrated.
PTCO
PSU TEMP CUTOFF
Ballast in thermal cutoff
PTCS
PAN/TILT CALIBRATE SENSOR (s/w versions prior to ver. 1.3)
Pan/tilt sensors not calibrated
PTER
PSU TEMP HIGH
The temperature on a PCB in the power supply unit or ballast is high. A fan might be defective or the
ambient temperature may be too high.
R1ER
GOBO WHEEL ROTATION ERROR
SHNA
SHUTTER NOT ADJUSTED
No shutter adjustment data in EEPROM
SHUE
SHUTTER ERROR
SLER
SAFETY LOOP ERROR
Lamp safety loop circuit activated: the lamp access hatch is open or lamp is too hot
SSTO
SYSTEM STATE TIMEOUT
Failure to communicate with module during self-check at startup. Service intervention required.
Fixture control possibly disabled, depending on nature of error.
TIER
TILT ERROR
TINA
TILT NOT ADJUSTED
Tilt needs to be adjusted by a qualified service technician.
TSER
TILT SENSOR ERROR
UECH
UPLOAD ERROR CHARGER
Could not upload new firmware to the Charger module.
UECM
UPLOAD ERROR CMY
Could not upload new firmware to the CMY module.
UECO
UPLOAD ERROR COOLING
Could not upload new firmware to the Cooling module.
UEEF
UPLOAD ERROR EFFECT
Could not upload new firmware to the Effects module.
UEPT
UPLOAD ERROR PAN/TILT
Could not upload new firmware to the Pan/Tilt Focus module.
UEPU
UPLOAD ERROR POWER UNIT
Could not upload new firmware to the Power Unit module.
UEUI
UPLOAD ERROR UI
Could not upload new firmware to the User Interface module.
UEZF
UPLOAD ERROR ZOOM/FOCUS
Could not upload new firmware to the Zoom Focus module.
UPLB
UPLOAD ERROR ON BALLAST (s/w versions prior to ver. 1.3)
UPLC
UPLOAD ERROR ON COOLING (s/w versions prior to ver. 1.3)
UPLD
DMX UPLOAD ERROR
An error occurred during upload via DMX. Check cabling and connections, and then restart.
UPLD
DMX UPLOAD ERROR
Firmware upload via DMX failed.
UPLE
UPLOAD ERROR ON EFFECT (s/w versions prior to ver. 1.3)
Table 5: Error messages
56
MAC III AirFX user manual